Sterling SSV 05/R operating instructions Maintenance

Page 25

SM4-605

SSV 05/R

5. Maintenance

»This chapter is intended for persons with skills in electrical and mechanical areas due to their training, experience and received

instructions.

Personnel using the instructions in this chapter must be in- structed of the regulations for the prevention of accidents, the operating conditions and safety regulations and their implemen- tation.

Ensure in each case that the personnel are informed accord- ingly.

For maintenance work taking place at heights of over approx. 6 feet (1829 mm), use only ladders or similar equipment and working platforms intended for this purpose. At greater heights, the proper equipment for protection against falling must be worn.

Use only suitable lifting gear which is in proper working order and load suspension devices with sufficient carrying capacity. Do not stand or work under suspended loads!

Ensure that the electric motors/switch cabinets are sufficiently protected against moisture.

Use only suitable workshop equipment.

Before starting maintenance work, appoint a supervisor.

Inform the responsible personnel before maintenance work on the system is started.

Never operate the equipment when partially dismantled.

All maintenance and repair work not described in this chapter may only be carried out by Sterling service personnel or authorized personnel (appointed by Sterling).

Maintenance 24

Image 25
Contents Sterling Material Processing Operating Instructions Single Conveyor Unit SSV 05/RSSV 05/R Sterling Material Processing Technical serviceEdition 08/99 SSV 05/R Parts and Service Department Table of contents SSV 05/R Technical data Safety instructions Safety instructionsSSV 05/R SSV 05/R Explanations and information SSV 05/R For your safety SSV 05/R SSV 05/R SSV 05/R For the safety of the units Installation instructions SSV 05/R General information SSV 05/R Installing the conveyor hopper SSV 05/R Installing the control and maintenance unit SSV 05/R Connecting the compressed-air supply SSV 05/R Electrical connection Functional description SSV 05/R Method of functioning Control and maintenance unitSet-up SSV 05/R Preparations Basic setting of the filling level in the conveyor hopperFilling level too low Filling level too highSet-up Maintenance SSV 05/R SSV 05/R Maintenance intervals Disassembly SSV 05/R Cleaning/replacing the filter cartridgeAdjusting the level probe SSV 05/R AssemblyTest steps SSV 05/R Trouble-shooting Problem RemedyTechnical data SSV 05/R Dimension sheet SSV 05/R Spare parts list SSV 05/R Pos Designation ID-No Maintenance and control unit Designation ID-No