Sterling operating instructions SSV 05/R Cleaning/replacing the filter cartridge, Disassembly

Page 28

SSV 05/R

5.2. Cleaning/replacing the filter cartridge

»

Switch off the unit.

Disconnect the mains plug.

Disassembly

Remove the filter cartridge (A).

Blow out the filter cartridge (A) from the inside out by means of com- pressed air or replace the filter.

Open the toggle-type fastener (B).

Fold the hopper lid (C) upwards.

Check the sieve (D) within the lid for material residue. Disassembling the sieve for cleaning: draw the sieve out of the fit of the sealing ring.

Clean the sieve (D) by means of compressed air.

Replace the sieve and sealing ring in case of damage.

A

C

B

D

SSV 05/R

SM4-605

Maintenance 27

Image 28
Contents Operating Instructions Single Conveyor Unit SSV 05/R Sterling Material ProcessingSSV 05/R Sterling Material Processing Technical serviceEdition 08/99 SSV 05/R Parts and Service Department Table of contents SSV 05/R Technical data Safety instructions Safety instructionsSSV 05/R SSV 05/R Explanations and information SSV 05/R For your safety SSV 05/R SSV 05/R SSV 05/R For the safety of the units Installation instructions SSV 05/R General information SSV 05/R Installing the conveyor hopper SSV 05/R Installing the control and maintenance unit SSV 05/R Connecting the compressed-air supply SSV 05/R Electrical connection Functional description Control and maintenance unit SSV 05/R Method of functioningSet-up Basic setting of the filling level in the conveyor hopper SSV 05/R PreparationsFilling level too low Filling level too highSet-up Maintenance SSV 05/R SSV 05/R Maintenance intervals SSV 05/R Cleaning/replacing the filter cartridge DisassemblySSV 05/R Assembly Adjusting the level probeSSV 05/R Trouble-shooting Problem Remedy Test stepsTechnical data SSV 05/R Dimension sheet SSV 05/R Spare parts list Maintenance and control unit Designation ID-No SSV 05/R Pos Designation ID-No