Delta 36-714 instruction manual Bolting the SAW to Floor, Blade Tilting and Raising Handwheels

Page 10

BOLTING THE SAW TO FLOOR

DISCONNECT MACHINE FROM

POWER SOURCE.

To bolt the saw to a permanent location, remove the nine screws which secure the dust chute inside the saw cabinet, six of which are shown at (C) Fig. 4. Also, remove the side panel below the motor cover by loosening all six screws (D).

Find the holes (E) Fig. 5 in the bottom of the saw and mark their position on the floor where you want to place the saw. Drill pilot holes in these spots and attach to floor using appropriate hardware.

Reassemble the dust chute and side panel.

C

D

Fig. 4

BLADE TILTING AND RAISING

HANDWHEELS

DISCONNECT MACHINE FROM

POWER SOURCE.

Place blade tilting handwheel (A) Fig. 6 on shaft (B) on the left side of the saw cabinet. Make certain slot (C) in handwheel is engaged with roll pin (D) on the shaft.

Place nylon washer (E) Fig. 7 on shaft then thread locking knob (F) Fig. 7, on shaft (G) and tighten securely.

Attach blade raising handwheel (H) Fig. 7 in the same manner.

A	E
A
	F
	B
	D

C

Fig. 6

10

E

Fig. 5

G

H

Fig. 7

Image 10

Contents Delta 10 Hybrid Saw Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionImportant Safety Instructions General Safety RulesStay ALERT, Watch What YOU are DOING, Additional Safety Rules for Table Saws Cutting the Workpiece Without the USEMotor Specifications Power ConnectionsGrounding Instructions Extension Cords Functional DescriptionForeword Carton Contents Unpacking and Cleaning AssemblyAssembly Tools Required Bolting the SAW to Floor Disconnect Machine from Power SourceBlade Tilting and Raising Handwheels Installing Drive Belt Do not Operate the SAW Without Right Table Wing Installed S C O N N E C T M a C H I N E F R O M Power SourceExtension Wings Installing Your Fence System Installing the SwitchAssembling Blade Guard and Splitter Assembly If alignment is necessary, loosen the two screws SAW Blade Aligning Splitter with BladeInstalling Tool Holders Installing Table InsertAdjusting Table Insert Installing Dust PortAssembling Miter Gage Locking Switch in OFF PositionOperation Starting and Stopping SAWChecking Blade Alignment Blade AlignmentAdjusting Blade Alignment Backlash AdjustmentsMiter Gage Operation and Adjustment Common Sawing OperationsNever USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING CROSS-CUTTINGConstructing a Push Stick RippingGuard Removed for CLARITY. Always USE the Guard Using Moulding Cutterhead Using Dado Head Using Auxiliary Wood Facing on RIP FencePower Tool Institute TroubleshootingConstructing a Featherboard Pushstick Constructing a Push StickMaintenance ServiceAccessories WarrantyPage Page Canadian PORTER-CABLE Delta Service Centers