Delta 36-714 Installing Table Insert, Adjusting Table Insert, Installing Tool Holders

INSTALLING TABLE INSERT

DISCONNECT MACHINE FROM POWER

SOURCE.

Lower saw blade and install table insert (P) Fig. 26, in the saw table. IMPORTANT: When installing the table insert, make certain to hold on to the blade guard (L). The insert will automatically release the holding action on the splitter and lower the blade guard when the insert is installed in the table opening.

Insert M5x20mm screw into hole (M) Fig. 26 and tighten.

ADJUSTING TABLE INSERT

Place a straight edge (B) Fig. 26A across the table at both ends of the table insert (A) as shown in Fig. 26A.

THE TABLE INSERT (A) SHOULD

ALWAYS BE LEVEL WITH THE TABLE.

If an adjustment is necessary, loosen screw (M) Fig. 26 and turn the adjusting screws (C) Fig. 26A, as needed, with allen wrench supplied.

INSTALLING TOOL HOLDERS

DISCONNECT MACHINE FROM POWER

SOURCE.

Install fence holders (A) Fig. 27 using four self-tapping screws (4).

Install wrench hook (B) using two self-tapping screws.

Install miter gage holder (C) Fig. 28 underneath the motor cover on the right side of the saw using four self- tapping screws.

INSTALLING DUST PORT

DISCONNECT MACHINE FROM

POWER SOURCE

Attach dust port (D) Fig. 29 using four self-tapping screws.

L

M

P

Fig. 26

C

A

B

C

Fig. 26A

B

A

Fig. 27

C

Fig. 28

D

Fig. 29

17