Delta 36-714 instruction manual Installing Drive Belt

Page 11

INSTALLING DRIVE BELT

DISCONNECT MACHINE FROM

POWER SOURCE.

First, lift motor and remove foam packing block from around motor.

While lifting motor (A) Fig. 8, place a 10-12 inch long piece of 2x4, or another similar thickness of wood, (B) Fig. 8 as shown. This will help prop up the motor and will make it easier to install the grooved belt, (C) Fig. 8A.

Place grooved belt (C) Fig. 8A in grooved pulley located behind the motor (shown in Fig. 8B) and the one directly above, located on the opposite end of the blade arbor. Ensure that the grooves of the belt completely make contact with the grooves in these pulleys.

Carefully lift motor and remove the block of wood. The weight of the motor will provide the correct tension on the belt.

The belt (D) Fig. 8D is shown installed correctly as seen through the open door in the side of the saw.

A

Fig. 8

C

Fig. 8A

Fig. 8B

D

Fig. 8D

B

11

Image 11

Contents Delta 10 Hybrid Saw Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsStay ALERT, Watch What YOU are DOING, General Safety RulesImportant Safety Instructions Cutting the Workpiece Without the USE Additional Safety Rules for Table SawsGrounding Instructions Power ConnectionsMotor Specifications Foreword Functional DescriptionExtension Cords Carton Contents Assembly Tools Required AssemblyUnpacking and Cleaning Blade Tilting and Raising Handwheels Disconnect Machine from Power SourceBolting the SAW to Floor Installing Drive Belt Extension Wings S C O N N E C T M a C H I N E F R O M Power SourceDo not Operate the SAW Without Right Table Wing Installed Installing the Switch Installing Your Fence SystemAssembling Blade Guard and Splitter Assembly If alignment is necessary, loosen the two screws Aligning Splitter with Blade SAW BladeInstalling Dust Port Installing Table InsertAdjusting Table Insert Installing Tool HoldersStarting and Stopping SAW Locking Switch in OFF PositionOperation Assembling Miter GageBlade Alignment Checking Blade AlignmentBacklash Adjustments Adjusting Blade AlignmentCommon Sawing Operations Miter Gage Operation and AdjustmentCROSS-CUTTING Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTINGGuard Removed for CLARITY. Always USE the Guard RippingConstructing a Push Stick Using Moulding Cutterhead Using Auxiliary Wood Facing on RIP Fence Using Dado HeadConstructing a Featherboard TroubleshootingPower Tool Institute Constructing a Push Stick PushstickService MaintenanceWarranty AccessoriesPage Page Canadian PORTER-CABLE Delta Service Centers