Delta 36-714 Extension Wings, S C O N N E C T M a C H I N E F R O M Power Source

Page 12

EXTENSION WINGS

D I S C O N N E C T M A C H I N E F R O M

POWER SOURCE.

Assemble left extension wing (A) Fig. 10A to the saw table. Align the three holes in the extension wing with the three holes (A) Fig. 9 in the side of the saw table. Place a 7/16" lockwasher, then a 7/16" flat washer on a 7/16- 20x1-1/4” hex head screw (all shown at (B) Fig. 9). Insert the screw through the hole in the extension wing and thread the screw into the tapped hole in the side of the table. Repeat this process for the two remaining holes in the extension wing and saw table.

With a straight edge (E) Fig. 10A, make certain the extension wing (A) is level with the saw table before tightening three bolts (B) Fig. 10 with an 18mm open end wrench. Starting with a bolt on one side, make sure the tables are lined up and then tighten that bolt. Then, move to the middle bolt and follow the same procedure of aligning and tightening. Then do the same for the bolt on the other end.

NOTE: MAKE SURE FRONT EDGE OF WING IS FLUSH TO OR SLIGHTLY BEHIND THE FRONT EDGE OF THE TABLE.

Place the right extension wing on the other side of the saw in the same manner.

DO NOT OPERATE THE SAW WITHOUT RIGHT TABLE WING INSTALLED.

12

B

A

Fig. 9

B

Fig. 10

E

A

Fig. 10A

Image 12

Contents Delta 10 Hybrid Saw Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Important Safety InstructionsStay ALERT, Watch What YOU are DOING, Additional Safety Rules for Table Saws Cutting the Workpiece Without the USEPower Connections Motor SpecificationsGrounding Instructions Functional Description Extension CordsForeword Carton Contents Assembly Unpacking and CleaningAssembly Tools Required Disconnect Machine from Power Source Bolting the SAW to FloorBlade Tilting and Raising Handwheels Installing Drive Belt S C O N N E C T M a C H I N E F R O M Power Source Do not Operate the SAW Without Right Table Wing InstalledExtension Wings Installing Your Fence System Installing the SwitchAssembling Blade Guard and Splitter Assembly If alignment is necessary, loosen the two screws SAW Blade Aligning Splitter with BladeInstalling Table Insert Adjusting Table InsertInstalling Tool Holders Installing Dust PortLocking Switch in OFF Position OperationAssembling Miter Gage Starting and Stopping SAWChecking Blade Alignment Blade AlignmentAdjusting Blade Alignment Backlash AdjustmentsMiter Gage Operation and Adjustment Common Sawing OperationsNever USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING CROSS-CUTTINGRipping Constructing a Push StickGuard Removed for CLARITY. Always USE the Guard Using Moulding Cutterhead Using Dado Head Using Auxiliary Wood Facing on RIP FenceTroubleshooting Power Tool InstituteConstructing a Featherboard Pushstick Constructing a Push StickMaintenance ServiceAccessories WarrantyPage Page Canadian PORTER-CABLE Delta Service Centers