Delta 36-714 instruction manual Assembling Blade Guard and Splitter Assembly

Page 14

ASSEMBLING BLADE GUARD AND SPLITTER ASSEMBLY

DISCONNECT MACHINE FROM POWER SOURCE.

MAKE SURE BLADE IS NOT ATTACHED. IF IT IS, REMOVE THE SAW BLADE FROM THE SAW USING THE SUPPLIED WRENCHES.

1.Fasten the rear splitter mounting bracket (A) Fig. 15, to the rear trunnion on the back of the saw using the two 1/4”-20 x 3/4″ hex head screws (B), 1/4” flat washers and 1/4” lock washers. Place flat washers, then lock washers onto the screw, then insert them through the holes in the splitter mounting bracket and into the tapped holes in the trunnion. Do not completely tighten the two screws (B) at this time.

2.Raise saw arbor to its highest position.

3.Using a 12 mm wrench, remove hex head screw and large washer (C) Fig. 16 from the inside splitter mounting bracket.

4.Remove the outer arbor flange and leave the inner arbor flange (F) Fig. 16 on the arbor.

4.Use a straight edge to check to see if the top and bottom of the inside splitter bracket (D) Fig. 17 is aligned with the inner arbor flange (E).

A

B

Fig. 15

F

Fig. 16

D

E

Fig. 17

14

Image 14

Contents Delta 10 Hybrid Saw Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionStay ALERT, Watch What YOU are DOING, General Safety RulesImportant Safety Instructions Additional Safety Rules for Table Saws Cutting the Workpiece Without the USEGrounding Instructions Power ConnectionsMotor Specifications Foreword Functional DescriptionExtension Cords Carton Contents Assembly Tools Required AssemblyUnpacking and Cleaning Blade Tilting and Raising Handwheels Disconnect Machine from Power SourceBolting the SAW to Floor Installing Drive Belt Extension Wings S C O N N E C T M a C H I N E F R O M Power SourceDo not Operate the SAW Without Right Table Wing Installed Installing Your Fence System Installing the SwitchAssembling Blade Guard and Splitter Assembly If alignment is necessary, loosen the two screws SAW Blade Aligning Splitter with BladeInstalling Tool Holders Installing Table InsertAdjusting Table Insert Installing Dust PortAssembling Miter Gage Locking Switch in OFF PositionOperation Starting and Stopping SAWChecking Blade Alignment Blade AlignmentAdjusting Blade Alignment Backlash AdjustmentsMiter Gage Operation and Adjustment Common Sawing OperationsNever USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING CROSS-CUTTINGGuard Removed for CLARITY. Always USE the Guard RippingConstructing a Push Stick Using Moulding Cutterhead Using Dado Head Using Auxiliary Wood Facing on RIP FenceConstructing a Featherboard TroubleshootingPower Tool Institute Pushstick Constructing a Push StickMaintenance ServiceAccessories WarrantyPage Page Canadian PORTER-CABLE Delta Service Centers