Delta 36-714 instruction manual SAW Blade, Aligning Splitter with Blade

Page 16

SAW BLADE

DISCONNECT MACHINE FROM POWER

SOURCE.

1.Raise the saw blade arbor to its maximum height. Assemble the saw blade (C) Fig. 23 to the saw arbor making sure the teeth of the blade point down towards the front of the table, as shown in Fig. 23. Assemble the flange (D) and arbor nut (E) to the saw arbor and tighten arbor nut (E) as far as possible by hand, being sure that the saw blade is against the inner blade flange.

2.Place the open end wrench (F) Fig. 23 on the flats on the saw arbor to keep the arbor from turning and tighten arbor nut (E) using the remaining wrench (G) Fig. 24, by turning the nut counterclockwise.

ALIGNING SPLITTER WITH BLADE

DISCONNECT MACHINE FROM POWER

SOURCE.

Use a straight edge to check to see if the saw blade (B) is aligned with the rear of the splitter (G) in Figs. 24 and

25.If alignment is necessary, loosen the screws (A) Fig. 25A which hold the splitter bracket to the rear trunnion. Align splitter (G) Fig. 25 with the saw blade, and tighten two bolts (A) Fig. 25A.

C

D

F

E

G

Fig. 23

B

G

Fig. 24

B

G

Fig. 25

A

Fig. 25A

16

Image 16

Contents Delta 10 Hybrid Saw Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionImportant Safety Instructions General Safety RulesStay ALERT, Watch What YOU are DOING, Additional Safety Rules for Table Saws Cutting the Workpiece Without the USEMotor Specifications Power ConnectionsGrounding Instructions Extension Cords Functional DescriptionForeword Carton Contents Unpacking and Cleaning AssemblyAssembly Tools Required Bolting the SAW to Floor Disconnect Machine from Power SourceBlade Tilting and Raising Handwheels Installing Drive Belt Do not Operate the SAW Without Right Table Wing Installed S C O N N E C T M a C H I N E F R O M Power SourceExtension Wings Installing Your Fence System Installing the SwitchAssembling Blade Guard and Splitter Assembly If alignment is necessary, loosen the two screws SAW Blade Aligning Splitter with BladeInstalling Table Insert Adjusting Table InsertInstalling Tool Holders Installing Dust PortLocking Switch in OFF Position OperationAssembling Miter Gage Starting and Stopping SAWChecking Blade Alignment Blade AlignmentAdjusting Blade Alignment Backlash AdjustmentsMiter Gage Operation and Adjustment Common Sawing OperationsNever USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING CROSS-CUTTINGConstructing a Push Stick RippingGuard Removed for CLARITY. Always USE the Guard Using Moulding Cutterhead Using Dado Head Using Auxiliary Wood Facing on RIP FencePower Tool Institute TroubleshootingConstructing a Featherboard Pushstick Constructing a Push StickMaintenance ServiceAccessories WarrantyPage Page Canadian PORTER-CABLE Delta Service Centers