Delta 36-714 instruction manual If alignment is necessary, loosen the two screws

Page 15

5.If alignment is necessary, loosen the two screws

(F) Fig. 18, align bracket (D) with the inner arbor flange (E), and tighten screws (F).

6.Loosely assemble large washer and screw (C) Fig. 18, to the inside splitter bracket. This screw and washer was removed in STEP 3.

D

F

C

E

7.Assemble the blade guard and splitter assembly (G) Fig. 19 between the large washer (C) and the splitter bracket and tighten hex head screw (H) with 12mm wrench.

8.Fasten the rear of the blade guard and splitter bracket assembly (G) Fig. 20, to the rear splitter mounting bracket using 5/16-18 x 5/8″ carriage bolt (J), 5/16” flat washer and 5/16-18 hex nut. Align the hole in the rear of the blade guard with the hole in the splitter bracket. Insert the 5/16-18x5/8″ carriage bolt through the holes. Place flat washer onto the bolt, then place nut on bolt and tighten.

IMPORTANT: The splitter (G) Fig. 20, has a notch (L) cut in the top edge. This feature will enable the blade guard to stay in the raised position when the table insert is removed to make blade changing easier. Raise the front of blade guard (M) Fig. 21, until the rear edge of the blade guard slips into notch (L) of splitter (G); the blade guard will stay in this position.

ALWAYS RETURN GUARD DOWN TO TABLE BEFORE OPERATING SAW. DO NOT OPERATE SAW WITHOUT THE TABLE

INSERT AND GUARD IN PLACE.

Fig. 18

G

H

C

Fig. 19

L G

J

Fig. 20

M

L

G

Fig. 21

15

Image 15

Contents Delta 10 Hybrid Saw Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsGeneral Safety Rules Important Safety InstructionsStay ALERT, Watch What YOU are DOING, Cutting the Workpiece Without the USE Additional Safety Rules for Table SawsPower Connections Motor SpecificationsGrounding Instructions Functional Description Extension CordsForeword Carton Contents Assembly Unpacking and CleaningAssembly Tools Required Disconnect Machine from Power Source Bolting the SAW to FloorBlade Tilting and Raising Handwheels Installing Drive Belt S C O N N E C T M a C H I N E F R O M Power Source Do not Operate the SAW Without Right Table Wing InstalledExtension Wings Installing the Switch Installing Your Fence SystemAssembling Blade Guard and Splitter Assembly If alignment is necessary, loosen the two screws Aligning Splitter with Blade SAW BladeInstalling Dust Port Installing Table InsertAdjusting Table Insert Installing Tool HoldersStarting and Stopping SAW Locking Switch in OFF PositionOperation Assembling Miter GageBlade Alignment Checking Blade AlignmentBacklash Adjustments Adjusting Blade AlignmentCommon Sawing Operations Miter Gage Operation and AdjustmentCROSS-CUTTING Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTINGRipping Constructing a Push StickGuard Removed for CLARITY. Always USE the Guard Using Moulding Cutterhead Using Auxiliary Wood Facing on RIP Fence Using Dado HeadTroubleshooting Power Tool InstituteConstructing a Featherboard Constructing a Push Stick PushstickService MaintenanceWarranty AccessoriesPage Page Canadian PORTER-CABLE Delta Service Centers