Delta 36-426 instruction manual Limited Edition 10″ Contractor’s Saw

Page 1

Limited Edition 10″ Contractor’s Saw

with 30″ Unifence® (Model 36-426)

with 30″ Biesemeyer® (Model 36-431)

PART NO. 422-19-651-0050 - 05-28-02

Copyright © 2002 Delta Machinery

INSTRUCTION MANUAL

To learn more about DELTA MACHINERY

visit our website at: www.deltamachinery.com.

For Parts, Service, Warranty or other Assistance,

please call 1-800-223-7278 (In Canada call 1-800-463-3582).

Image 1

Contents Limited Edition 10″ Contractor’s Saw General Safety Rules Properly Support Long or Wide workpieces Additional Safety Rules for Table SawsGrounding Instructions Power ConnectionsMinimum Gauge Extension Cord Extension CordsUnpacking and Cleaning Unifence T-SLOT Rail Fence System Unpacking Biesemeyer T-SQUARE Fence System1718 Page Assembling SAW Stand Assembly InstructionsAssembling SAW to Stand Motor Assembling Blade Tilting HandwheelAssembling Motor to Motor Mounting Plate Assembling Motor and Motor Mounting Plate to SAW Page Connecting Motor Cord to Switch Assembly Assembling Blade Guard and Splitter Assembly If an alignment is necessary, loosen the two screws Page Assembling Extension Wing Assembling Switch to Extension WingUnifence Assembly Instructions Assembling Table Board to SAW BA C B Assembling Unifence Table to SAW Assembling Unifence Guide Rail Assembling Rail Stop Setting T-SLOT Rail StopAssembling Unifence Body to Guide Rail Assembling Cursor to Unifence BodyAssembling Unifence to Unifence Body Biesemeyer T-SQUARE Fence System Assembly InstructionsPage 8″ M ″ L 4 ″ K Page Starting and Stopping SAW Locking Switch OFF PositionOverload Protection Tilting the Blade Raising and Lowering the BladeChecking Blade Alignment Miter Gage Operation and Adjustment Adjusting Blade AlignmentChanging the SAW Blade Adjusting Table InsertDust Chute Storing the Miter GAGE, RIP FENCE, and Arbor WrenchesFence Operation Adjusting Fence Parallel to Miter Gage Slots Adjusting Clamping Action of Fence Locking Handle Adjusting Fence Degrees to TableRepositioning Motor for Storage Protecting Cast Iron Table from Rust Common Sawing OperationsCROSS-CUTTING Unifence can be Used AS a CUT-OFF Gage For Unifence Systems onlyConstructing a Push Stick Ripping with the UnifenceRipping on Left Side of SAW Blade Using Auxiliary Wood Facing on RIP FenceUsing Accessory Moulding Cutterhead Shows a typical dado operation using Miter gage as a guide Using Accessory Dado HeadConstructing a Featherboard Biesemeyer T-SQUARE Fence System Fence Operation Adjusting Fence Parallel to Miter Gage SlotsLubrication Adjusting Clamping Action of Fence Locking HandleConstructing a Push Stick PushstickDeluxe Uniguard Blade Guard Blade Guard AccessoriesAccessories Page Page Canadian PORTER-CABLE Delta Service Centers