Delta 36-426 instruction manual

V

T U

Fig. 87

X

11.After the holes have been drilled in the edge of the front and rear extension table board, fasten both front and rear rail to table using the 1-1/2″ flat head Phillips screws (T) Fig. 87, 1-1/4″ O.D. flat washers (U) and hex nuts (V). NOTE: The 1-1/4″ flat washer cannot be used on the end holes (X) shown covered by clamp.

12.Lay the guide tube (B) Fig. 88, on the saw table, and line up the threaded holes (C) on bottom of guide tube (B) with the through-holes (D) on the front rail (A) in seven places.

B

C

A

D

Fig. 88

13.Position the guide tube (B) Fig. 89 on the front rail and fasten the guide tube to the rail using the 1/4-20 x 1/2″ long hex head screws (G) and lockwashers in seven places. Place lockwasher onto screw and assemble into rail.

B

G

Fig. 89

29