4.To move the fence along the guide rail, simply lift up clamp lever (A), Fig. 112, slide fence to desired position on the rail, and push down on clamp lever (A) to lock fence in place.
5.The distance the fence is positioned away from the blade is indicated by the two witness lines (B) and (C) Fig. 113, located on the cursor (D). The witness lines (B) and
(C) indicate the distance the fence is positioned away from the saw blade. Witness line (B) indicates the distance the fence is away from the blade when the fence is in the horizontal position (Fig. 111), and witness line (C) indicates the distance the fence is away from the blade when the fence is in the vertical position (Fig. 110). To adjust cursor (D), make a test cut with the fence in either the vertical or horizontal position, measure the distance of the finished cut and move the cursor (D) by loosening the two screws (E) Fig. 113. After adjustment is completed, tighten the two screws (E).
6.To remove the fence and fence body assembly (F) Fig. 114, from the guide rail, lift up on fence clamping lever (A) and turn lever (A) to the CCW indent position. The fence assembly (F) can then be pulled straight off the guide rail and removed, as shown in Fig. 114.
ADJUSTING FENCE
PARALLEL TO
MITER GAGE SLOTS
The fence (A) Fig. 115, should be adjusted so it is parallel to miter gage slots (B). To check and adjust, move the fence (A) until the bottom front edge of the fence is in line with the edge of the miter gage slot, and push down on fence clamping lever (C). Check to see that the fence is parallel to the miter gage slot the entire length of the table. If the rear of the fence must be moved, slightly tighten or loosen one of the adjustment plugs (D) or (E) Fig. 115, using the arbor wrench or 7/8″ wrench, until the fence is parallel with the miter gage slot. IMPORTANT:
DO NOT OVERTIGHTEN ADJUSTMENT PLUGS (D) AND (E) FIG. 115. VERY LITTLE MOVEMENT OF THESE ADJUSTMENT PLUGS IS NECESSARY WHEN ADJUSTING THE FENCE PARALLEL WITH THE MITER GAGE SLOT.
A 
Fig. 112
B C
E D
E
Fig. 113
F
A 
Fig. 114
A
E
B 
D
C
Fig. 115
36