Delta 36-426 Storing the Miter GAGE, RIP FENCE, and Arbor Wrenches, Dust Chute, Fence Operation

STORING THE MITER GAGE, RIP FENCE, AND ARBOR WRENCHES

1.When not in use, the miter gage (A) Fig. 108 can be stored through the hole located at the front side of the stand.

2.The rip fence (B) Fig. 108 can be conveniently stored out-of-the-way on the stamped ledges on the right side of the saw stand.

3.Arbor wrenches (C) Fig. 109, can be stored on one of the two notched legs.

B

A

Fig. 108

DUST CHUTE

The saw stand support panel (D) Fig. 109 also serves as a natural built-in dust chute. This dust chute (D) allows the sawdust to conveniently escape out the rear of the saw stand and away from the work area.

FENCE OPERATION

1.Before operating fence, make sure the fence is adjusted parallel to miter gage slot, as explained later on in this manual.

2.For most normal ripping operations of standard size lumber, the fence is used in the vertical position, as shown in (A) Fig. 110.

3.When ripping thin stock, use the fence in the horizontal position, (B) Fig. 111.

D

C

Fig. 109

A

Fig. 110

B

Fig. 111

35