Delta 36-426 instruction manual Assembling Blade Guard and Splitter Assembly

Page 16

2.Fig. 27, illustrates the motor cord connected to the switch assembly.

Fig. 27

ASSEMBLING BLADE GUARD AND SPLITTER ASSEMBLY

WARNING: DISCONNECT MACHINE FROM POWER SOURCE.

B

A

1.Fasten the rear splitter mounting bracket (A) Fig. 28, to the rear trunnion using the two 1/4-20 x 3/4″ hex head screws (B) and flat washers. Do not completely tighten the two screws (B) at this time.

2.Raise saw arbor to its highest position. With wrenches supplied, remove the saw blade from the saw. Refer to section “CHANGING THE SAW BLADE” of this manual.

3.Remove screw and large washer (C) Fig. 29, from the inside splitter mounting bracket.

4.Use a straight edge to check to see if the top and bottom of the inside splitter bracket (D) Fig. 30 is aligned with the inner arbor flange (E).

Fig. 28

C

Fig. 29

D

E

Fig. 30

16

Image 16

Contents Limited Edition 10″ Contractor’s Saw General Safety Rules Additional Safety Rules for Table Saws Properly Support Long or Wide workpiecesPower Connections Grounding InstructionsExtension Cords Minimum Gauge Extension CordUnpacking and Cleaning Unifence T-SLOT Rail Fence System Biesemeyer T-SQUARE Fence System Unpacking1718 Page Assembling SAW Stand Assembly InstructionsAssembling SAW to Stand Motor Assembling Blade Tilting HandwheelAssembling Motor to Motor Mounting Plate Assembling Motor and Motor Mounting Plate to SAW Page Connecting Motor Cord to Switch Assembly Assembling Blade Guard and Splitter Assembly If an alignment is necessary, loosen the two screws Page Assembling Switch to Extension Wing Assembling Extension WingUnifence Assembly Instructions Assembling Table Board to SAW BA C B Assembling Unifence Table to SAW Assembling Unifence Guide Rail Setting T-SLOT Rail Stop Assembling Rail StopAssembling Cursor to Unifence Body Assembling Unifence Body to Guide RailBiesemeyer T-SQUARE Fence System Assembly Instructions Assembling Unifence to Unifence BodyPage 8″ M ″ L 4 ″ K Page Starting and Stopping SAW Locking Switch OFF PositionOverload Protection Raising and Lowering the Blade Tilting the BladeChecking Blade Alignment Adjusting Blade Alignment Miter Gage Operation and AdjustmentAdjusting Table Insert Changing the SAW BladeDust Chute Storing the Miter GAGE, RIP FENCE, and Arbor WrenchesFence Operation Adjusting Fence Parallel to Miter Gage Slots Adjusting Clamping Action of Fence Locking Handle Adjusting Fence Degrees to TableRepositioning Motor for Storage Protecting Cast Iron Table from Rust Common Sawing OperationsCROSS-CUTTING For Unifence Systems only Unifence can be Used AS a CUT-OFF GageRipping with the Unifence Constructing a Push StickUsing Auxiliary Wood Facing on RIP Fence Ripping on Left Side of SAW BladeUsing Accessory Moulding Cutterhead Using Accessory Dado Head Shows a typical dado operation using Miter gage as a guideConstructing a Featherboard Adjusting Fence Parallel to Miter Gage Slots Biesemeyer T-SQUARE Fence System Fence OperationAdjusting Clamping Action of Fence Locking Handle LubricationPushstick Constructing a Push StickBlade Guard Accessories Deluxe Uniguard Blade GuardAccessories Page Page Canadian PORTER-CABLE Delta Service Centers