9.With the blade guard (L) Fig. 35, in the raised position, assemble the saw blade (K) on the saw arbor with two arbor wrenches supplied.
10.Use a straight edge to check to see if the saw blade is aligned with the rear of the splitter (G) in Figs. 36 and
37.If alignment is necessary, loosen the screws (A) Fig. 37, align splitter (G) with the saw blade, and tighten two screws (A).
11.Lower saw blade and install table insert (P) Fig. 38, in the saw table. IMPORTANT: When installing the table insert, make certain to hold on to the blade guard (L). The insert will automatically release the holding action on the splitter and lower the blade guard when it is installed in the table opening.
L
K
Fig. 35
G
Fig. 36
G
A
Fig. 37
L
P
Fig. 38
18