UNIFENCE ASSEMBLY INSTRUCTIONS ASSEMBLING TABLE
BOARD TO SAW
1.Lay the table board upside down on the floor or bench, Fig. 44.
2.Assemble the two table legs (A) Fig. 45 to the bottom of the table using eight #8 x 3/4″ self tapping wood screws. NOTE: Refer to Fig. 43 for the hole location for the 30″ Unifence table legs.
3.Insert foot adapter (T) Fig. 46, into the bottom of each leg (A). Assemble the 3/8″ jam nut (V) Fig. 46, approximately 3/4 of the way onto leveling screw (W). Thread the leveling screw (W) Fig. 46 into foot adapter. Fig. 47 illustrates the foot leveling assembly on the table leg. Assemble the remaining foot assembly to the other table leg in the same manner. NOTE: Height adjustments can be made later.
Fig. 43
Fig. 44
A
Fig. 45
Fig. 46 | Fig. 47 |
20