ASSEMBLING MOTOR AND MOTOR MOUNTING PLATE TO SAW
WARNING: WHEN ASSEMBLING THE MOTOR AND MOTOR MOUNTING PLATE TO THE SAW, MAKE CERTAIN THE MACHINE IS DISCONNECTED FROM THE POWER SOURCE.
1.Depress two pins (X) Fig. 16 and insert into holes (D) in each side of bracket (B). Pins are spring (Y) loaded from factory.
2.Position motor and motor mounting plate (A) Fig. 17 below bracket (B) to allow bracket arm to slide through large opening in motor mounting plate (A).
3.Depress pins (C) Fig. 17, on both sides of bracket
(B) and rotate motor mounting plate (A) until pins (C) are engaged in holes (D) Fig. 16, of motor mounting plate
(A).
4.Fig. 18 illustrates the motor and motor mounting plate assembled to the rear of the saw.
A
X
Y
B X
D 
Fig. 16
C
B
C
A
Fig. 17
Fig. 18
13