DeWalt DWX726 instruction manual Product Stability Test FIG

WARNING: STABILITY HAZARD. If the tool’s mounting holes do not line up with the slots in the mounting rails, mount the miter saw or planer to a piece of 3/4 inch (19 mm) plywood (See Figure 15 for dimensions). The plywood must be a minimum of 4 inch (101.6 mm) wider than the tool base being mounted and a minimum depth of 16 inch (406.4 mm). Plywood must be at least as deep as the tool base being mounted. Drill 3/8 inch (9.4 mm) holes near both ends of the plywood to align with the slots in the mounting rails as described in Attaching the Tool. Other hardware (not supplied) may be necessary under these circumstances.

WARNING: STABILITY HAZARD. All purchased hardware must be a minimum of Grade 2. Hardware should be 1-1/4 inch (31.8 mm) longer than the thickness of the tool base you are assembling.

NOTICE: To prevent binding and/or inaccuracy, ensure the plywood is not warped or uneven. If binding and/or inaccuracy occurs, replace the plywood with a non-warped, even piece of plywood.

PRODUCT STABILITY TEST (FIG. 16–17)

The rolling miter saw/planer stand is designed to be used in conjunction with a wide variety of miter saws, compound miter saws, sliding compound miter saws and planers.

WARNING: Any tool used with this stand must be properly positioned and secured to ensure stability and to prevent inadvertent tipping.

English

FIG. 14	FIG. 15
CC
	MINIMUM OF
	16" (406.4 mm)	15"
	MUST BE AT
		((381 mm)
EE	LEAST AS	BOTH
	DEEP AS THE
		SIDES
DD	SAW BEING
	MOUNTING
AA	1" (25.5 mm)

WIDTH OF SAW + 4" (101.6 mm)

1" (25.5 mm)	1" (25.5 mm)
	MOUNT MITER
SAW IN SHADED
	AREA

3/8" (9.5 mm)

DIAMETER

HOLES, ALL 4

CORNERS

2" (50.8 mm)

MINIMUM BOTH

SIDES

1" (25.5 mm)

7