Carrier KH_233P, KH_123P, KC_183P, KC_233P, KC_223P Masonry Construction, Personal Injury Hazard

Page 11

11.Caulk joints in wood frame as required. If wall thickness is 7” or more, add aluminum flashing over bottom of frame opening to ensure no water can enter area between inner and outer wall.

12.Remove the chassis from the unit cabinet.

!CAUTION

PERSONAL INJURY HAZARD

Failure to follow this caution may result in personal injury.

Be careful when handling chassis. Sharp edges on coil fins can cause personal injury.

13.Slide the empty cabinet into the wall opening and into wooden frame. Approximately 2-1/2“ of the cabinet should be in the room. The rest of the cabinet should be positioned through and outside the wall. (See Fig. 25.) Maintain proper slope for condensate drain operation. Bottom rail should be resting firmly on bottom board of wooden frame.

14.Secure bottom rail to wood frame with two large wood screws (1” long) using the two holes in the bottom of the channel. (See Fig. 26.)

15.There are screw holes in the cabinet (4 each side, 4 top) which are used to secure the cabinet to the wooden frame. With the cabinet in its final position, drill holes in the wooden frame using the screw holes in the cabinet as a guide. After the holes have been drilled, secure the cabinet to the wooden frame using field-supplied screws. See Fig. 27.

16.Caulk around wood frame and wall opening on outside wall for a water-tight seal.

17.Optional caulking between the cabinet and the wooden frame may be done on inside wall. Caulking provides an air seal around the cabinet. Decorative wood trim may be added to provide a more pleasing appearance.

18.Lift chassis and carefully slide it into the cabinet. Be sure that it is firmly seated towards the rear of the cabinet.

!CAUTION

PERSONAL INJURY/UNIT OPERATION HAZARD

Failure to follow this caution may result in personal injury and/or damage to unit.

Do not push on the controls or the coil when installing chassis. Personal injury and/or unit damage could result.

19.Install the front panel

20.Plug in the unit.

A06743

Fig. 26 ---Securing Bottom Rail of Cabinet

A06744

Fig. 27 ---Securing Cabinet to Frame

MASONRY CONSTRUCTION

The air conditioner is installed the same way as the Wall Installation section with a few exceptions. Follow all local and national building codes.

The cabinet can be secured to the masonry by using masonry nail or masonry anchor screws.

Another installation technique would be to construct a frame of

2 x 4s and install the frame between the wall opening and the cabinet. The frame must be securely anchored to the masonry wall opening.

Use a lintel to support masonry above wall opening. Install exterior cabinet support brackets.

A06742

Fig. 25 ---Cabinet Location in Wall

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Date Installed Remote Control UnitTable of Contents Airc onditioner Safety ConsiderationsIntroduction 23K Cooling only including models Electrical SpecificationsElectrical Shock Hazard Unit Operation Hazard Tips Before InstallationPower Supply Cord Ground Installation InstructionsPersonal INJURY/UNIT Operation Hazard Select the Best LocationUnit Damage Hazard Assembly of the side shutters curtains to the cabinetSecure Shutters Reinstalling Front Panel AssemblyComplete the installation Drain Hose Storm Window ApplicationsWall Installation Location Wall InstallationPersonal Injury Hazard Masonry ConstructionOperating Instructions How to Use Remote ControlAir Filter Removal Care and MaintenanceTroubleshooting Guide Cleaning the Air FilterIf Your Unit does not WORK, Follow These Steps in Order Carrier Room AIR Conditioner Full WarrantyCarrier will not be Responsible for Catalog NoOMKCKH---2 Instrucciones de Instalación y funcionamiento Contenido Introducción Precauciones DE SeguridadNota 10K-14K modelos Sólo con enfriamiento 23K Especificaciones EléctricasRiesgo DE Descarga Eléctrica Cable Eléctrico Consejos Para Antes DE LA InstalaciónRiesgo DE Operación Errática DE LA Unidad Aperturas de la ventana Instrucciones DE InstalaciónRiesgo DE Operación Errática DE LA Unidad Y Lesiones Paso 1-Seleccione la mejor ubicación posiblePaso 3-Montaje del canal inferior y superior en la caja Serpentín Chasis TiradorPaso 8-Vuelva a instalar el panel frontal Riesgo DE Daño a LA UnidadPaso 6-Instalación de la caja Paso 7-Fije las persianasEl instalador tendrá que suministrar y cortar la tabla Instalaciones CON Contraventana8 pulg. mín Instalación EN LA ParedRiesgo DE Lesiones Personales Instalación del marcoInstrucciones DE Funcionamiento Construcción EN MamposteríaModo de empleo Mando a distanciaLimpieza del filtro de aire Solución DE ProblemasCuidado Y Mantenimiento Desmontaje del filtro de aireCarrier no Será Responsable POR Nº de catálogo OMKCKH---2 MOT D’ACCUEIL AU Propriétaire DE CET Équipement Table DES Matières Introduction Pour Votre SécuritéRisque D’ÉLECTROCUTION Caractéristiques ÉlectriquesCordon Électrique Vis 3/4 poVis 1/4 po Rondelle Rail inférieurLatéral Obstacle Sol Étape 1-Choix de l’endroit le plus appropriéÉtape 5-Pose des supports de montage et du premier joint Vis Philips côté droitÉtape 3-Pose des rails supérieur et inférieur du boîtier Étape 4-Pose des volets latéraux rideaux au boîtierÉtape 9-Calfeutrage Étape 6-Pose du boîtierÉtape 7-Pose des volets Étape 8-Pose du panneau avantInstallation SUR UN Contrechâssis Intercalaire Fourni PAR LinstallateurA06740 Installation MuraleRisque DE Blessures Corporelles Pose du cadreMaçonnerie Mode D’EMPLOIMode d’emploi de la télécommande TélécommandeEntretien de fin de saison Entretien ET MaintenanceDépose du filtre Nettoyage du filtre à airCarrier NE Pourra Être Tenu Responsable DE

KC_141P, KH_233P, KC_223P, KC_233P, KC_183P specifications

Carrier has made significant strides in the HVAC industry with its innovative series of air conditioning systems, particularly the KH_123P, KC_183P, KC_233P, KC_223P, and KH_233P models. These models are a testament to Carrier's commitment to delivering advanced technology, energy efficiency, and enhanced comfort in climate control.

The KH_123P model is a compact ductless system that provides effective cooling and heating solutions for residential spaces. With its sleek design, it seamlessly integrates into any home decor. The unit features advanced inverter technology, allowing for variable speed operation that adjusts to the cooling demand, significantly reducing energy consumption. It also boasts low ambient cooling capability, making it ideal for use in various climates.

Next, the KC_183P and KC_233P models are designed for medium to large spaces, providing powerful climate control with a focus on quiet operation. Both models are equipped with high-efficiency scroll compressors that ensure reliable performance while minimizing noise levels. Additionally, these units feature multiple fan speeds and advanced air filtration systems, which improve indoor air quality by capturing dust, allergens, and other pollutants.

The KC_223P model stands out for its smart technology integration. It supports Wi-Fi connectivity, allowing users to control the system remotely via a smartphone app. This feature enables scheduling, temperature adjustments, and monitoring of energy usage from virtually anywhere. The KC_223P also includes precise temperature control and zoning capability, creating comfort zones tailored to individual preferences throughout the home or office.

The KH_233P model further enhances energy efficiency with its EcoMode setting, which optimizes performance for lower energy consumption during periods of low activity. This model is also equipped with advanced diagnostics and self-cleaning functions, reducing maintenance needs and extending the unit's lifespan.

All of these Carrier models come with a robust warranty and are backed by Carrier’s storied reputation for quality and innovation. With their blend of advanced technology, efficiency, and user-friendly features, the KH_123P, KC_183P, KC_233P, KC_223P, and KH_233P systems are stellar choices for anyone looking to enhance their indoor climate comfort. Carrier continues to set the standard in the HVAC sector through these versatile and high-performing solutions.
Top Page Image Contents