Black & Decker BPSC2135 manual Maintenance, Lubrication, Cleaning, Tool Care, Accessories

ENGLISH

(8mm) as shown in Figure 9 they should be replaced. To reinstall, push new brush back into brushbox. If replacing existing brush, maintain same orientation as when removed. Replace the brush cap (do not overtighten). Replace end cap and two screws. Tighten securely.

Maintenance

Your Black & Decker power tool has been designed to operate over a long period of time with a minimum of maintenance.Continuous satisfactory operation depends upon proper tool care and regular cleaning.Your tool is not user-serviceable. Take the tool to an authorized Black & Decker repair agent. This tool should be serviced at regular intervals or when showing a noticeable change in performance.

Lubrication

Black & Decker power tools are properly lubricated at the factory and are ready for use. Tools should be re-lubricated regularly , depending on usage. This lubrication should only be attempted by trained power tool repair persons, such as those at Black & Decker service centers or by other qualified service personnel. Closed-type, grease-sealed ball bearings are used throughout. These bearings have sufficient lubricationpacked in them at the factory to last the life of the chop saw.

Cleaning

Warning: unplug the tool before you use a cloth to clean the housing.With the motor running, blow dirt and dust out of all air vents with dry air at least once a week. Wear safety glasses when performing this. Exterior plastic parts may be cleaned with a damp cloth and mild detergent. Although these parts are highly solvent resistant, NEVER use solvents.

Blowing dust and grit out of the main housing by means of an air hose is recommended and may be done as often as dirt is seen collecting in and around the air vents. Always wear proper eye and respiratory protection.

Tool Care

Avoid overloading the machine.Overloading will result in a considerable reduction in speed and efficiency and the unit

will become hot. In this event,run the machine at no load for a minute or two until cooled to normal working temperature by the built in fan. Switching your machine on and off whilst under load will considerably reduce the life of the switch.

Important

To ensure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified organizations, always-using identical replacement parts. Unit contains no user serviceable parts inside.Blowing dust and grit out of the main housing by means of an air hose is recommended and may be done as often as dirt is seen collecting in and around the air vents. Always wear proper eye and respiratory protection.

Note: Unit may be converted to a 3-wire twist lock cord set at an authorized service center.

Accessories

The performance of any power tool is dependent upon the accessory used. Black & Decker accessories areengineered to high quality standards and are designed to enhance the performance of power tool.

Note: Accessory must be rated for use at speed equal to or higher than nameplate RPM of tool with which it is being used.

Caution: The use of any other accessory not recommended for use with this tool could be hazardous.Use only high-strength Type 1 organic bonded wheels rated 4100 rpm or higher. Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized service center.

Technical data
Specifications		BPSC2135
POWER	W	2100
NO-LOAD SPEED	/min	3800
MAX. DIAMETER	mm	355
Weight	kg	15.5

8