Craftsman 113.29921 owner manual Checking Table Insert, Leveling Tab Edge

Assembly (continued) .....

Checking Table Insert

The table insert must be flush with the surface of the saw table to keep the workpiece from hanging up or binding with the sawbtade as the workpiece is cut by the saw-

blade,

1 Lower sawblade beneath the table insert and check to be sure the screw fastening the insert in place is snug

2 Use a straight edge to check near each of the eight leveling tab positions to determine if the insert is flush with the surface of the saw table at all eight leveling tab positions

3.tf insert is not flush with table surface, loosen insert fastening screw and pull insert forward to lift from saw table

4, Bend with pliers or tap with a hammer, as required, to make the insert flush with the table top,

Leveling

Tab

Edge

. /--

\

\

18