Craftsman 113.29921 owner manual Push Block

Basic Saw Operations (continued)-

Ripping(continued)

Once the trailing end is on the table: Push Stick

When "width of rip" is 2" or wider, use the push stick to finish pushing the work all the way past the blade

When	"width of rip" is	narrower than 2" the push stick	Guard	Auxiliary
				fence
cannot	be used because	the guard will interfere_ use the		\
auxiliary fence and push block.,				\

Attach auxiliary fence to rip fence with two "C" clamps

Feed the workpiece by hand along the auxiliary fence	Push Block
until the end is approximately 1" past the front edge of the
table, Continue to feed using the push block.
Hold the workpiece in position and install the push block
by sliding it on top of the auxiliary fence (this may raise
guard)

Workpiece

32