Craftsman 113.29921 owner manual Installing Blade Guard, Truss Head Screw

Installing Blade Guard

1.From the bag Iabeled "Guard" remove the following hardware:

*2 Truss Head Screws, t/4-20 x 5/8" Long

*2 Socket Head Set Screws, 1/4-20 x 7/8" Long *4 Fiat washers, 17/64 x 9/16 x 3/64

*2 Hex Nuts 1/4_20

*4 Lockwashers, 1/4 ExternalType

*2 Wing Nuts, 1/4-20

*2 Square Nuts, 1/4-20

1Spreader Support

1Spreader Bracket

1Spreader Clamp

From among the loose parts find the following: 1 Blade Guard

Items marked with asterisk (*) are shown actual size

2, Make sure the blade is all the way up and square with table,

3, Position spreader support on rod until it is even with the end of the rod.

4 Assemble the 7/8 inch long set screws, nuts, lock- washers and washers to the spreader support bracket and slip the nuts into the slot in the spreader support,

5 Finger tighten only the hex nuts

NOTE: Be sure to put the socket head set screw through the slot shaped holes in the spreader bracket (see itlus- tration)_ This allows the guard and spreader to be Iined up with the blade Be sure the socket end of the set screw is at the hex nut end of the assembly,

		X		©
8 In	Socket1/4-20Head7/8
	Set Screw		1/4	In,, External
Truss Head Screw
			Lockwasher
Q	1/4-20	17164I°D.
114-20HexNut Square Nut		Flat Washer	1/4-20 Wing Nut

Spreader Support

Spreader Bracket

\

Blade Square

With Table

Even With Rod

= i...........

Holes Up

Round Hole

On Side

- Leckwasher

ex Nut --='_

19