Multi-Tech Systems MMV1600 Specifications Async Data Channels, System Control, Composite Link

Page 17

1.8 Specifications

1.8.1

Async Data Channels

Number of Channels

Up to sixteen (#MMV16XXC), or

 

up to thirty-two (#MMV32XXC)

Maximum Speed

19,200 bps

All Channels

 

Channel Speeds

All standard speeds from 300 bps to 19.2K bps

Data Format

Asynchronous: 5, 6, 7, or 8 data bits, with 1,1.5, or 2 stop bits

Parity

Odd, even, or none

Local Echo

On or off selectable for each channel

Flow Control

Xon/Xoff, CTS on/off, or HP ENQ/ACK selectable for each channel

Pacing

On or off selectable for each channel, DTR on/off, or Xon/Xoff

Interface

RS232C/CCITT V.24; 25-pin female D connectors

1.8.2

System Control

Local Access

Through MultiMux’s RS232C “Command Port”

Remote Access

Through MultiMux’s internal dial-up CCITT V.22bis/V.22, Bell 212A/103 (2400/1200/300

 

bps) command modem Device

 

Any asynchronous keyboard terminal, PC in terminal mode (local access), or any standard

 

dial-up 2400/1200/300bps V.22bis/V.22, 212A/103 modem (remote access)

Command Functions

Menu-driven/help screen approach. Commands to select channel speeds, flow

 

control methods, listing of parameters, help screens, storing of configurations, downline

 

loading, status reporting, echo controls, resets, pacing, parity, stop bits, response time

 

priorities, test modes, modem configurations, and other parameters.

Diagnostics

Memory tests, Local and Remote Digital Loop tests, Switch test, LED test, Non-Volatile RAM

 

test, Watchdog Timer, and Voice/fax Channel Loopback test.

1.8.3 Composite Link

Number of Links

Two (Links A and B)

Data Format

Synchronous

Link Speeds

Up to 256K bps

Link Protocol

Proprietary modified HDLC

Error Correction

16-bit CRC block check with ARQ

Interface

RS232C/CCITT V.35/V.24, or use MultiMux integral DSU

1.8.4

 

Internal DSU:

 

DescriptionIntegral card DSU, synchronous and full duplex over DDS network, 4-wire non-loaded metallic wire pairs or LADS (Local Area Data Set) at transmission speeds of 2400,4800, 9600,

19,200 or 56,000 bps

Line InterfaceDDS interface with a RJ48S 8-position keyed jack

1.8.5

Sync Data Channel

Number of Channels

One (Port B)

Data Format

Synchronous

Channel Speed

Up to 128K bps

Channel Protocol Any Synchronous HDLC

Interface

RS232C/CCITT V.35/V.24; 25-pin male D connector

Image 17
Contents MultiMux Page Record of Revisions RevisionDescription MultiMux #MMV1600C #MMV3200CTable of Contents Operating Procedures CommandsTroubleshooting Service, Warranty and Tech SupportTables AboutThisManual Service, Warranty and Tech Support 1.1 Statistical Multiplexing BackgroundDescription of Statistical Multiplexing Product Description CommunicationsMultiMux MMV1600/3200 Series Block Diagram Page Networking System Features Voice/FaxDual Composite Links Dynamic Load Balance Command Modem Channel Switching Diagnostics Parameter MemorySynchronous Data Channel Dynamic BufferingResponse Time Control DOC Terminal Equipment FCC Regulations for Telephone Line InterconnectionAU7USA-18883-DE-N DSU AU7USA-20328-MD-ESystem Control Specifications Async Data ChannelsComposite Link Internal DSUElectrical/Physical Voice ChannelsCompatibility DtmfModel Description Configuration DescriptionConfiguration Configuration 1 Composite Link Configuration Configuration 1 Local Site Channel ParametersConfiguration 1 Remote Site Channel Parameters Configuration 2 Composite Link Configuration Remote Site Configuration 3 Remote Site 2 Channel Parameters Configuration 3 Local Site Channel ParametersConfiguration 3 Remote Site 1 Channel Parameters Configuration 4 Local Site Voice/Fax Channel Parameters Configuration 4 FXO to FXSConfiguration 4 Remote Site Voice/Fax Channel Parameters Configuration 5 E&M Configuration 5 Remote Site Voice/Fax Channel Parameters Configuration 5 Local site Voice/Fax Channel ParametersConfiguration 6 FXS to FXS Configuration 6 Remote Site Voice/Fax Channel Parameters Configuration 6 Local Site Voice/Fax Channel ParametersRemote Site Configuration 7 Remote Site Voice/Fax Channel Parameters Configuration 7 Local Site Voice/Fax Channel ParametersConfiguration 8 LAN to LAN Page Cabling Procedure InstallationProcedureStepProcedure External Modem/DSU with RS232C InterfaceV.35 Interface Step ProcedureSync Data Channel Port B only Async ChannelComposite Link Cabling Supervisory Console Configuration ProcedureCommand Modem Step Procedure Voice/Fax Channels Step Procedure Async ChannelsPage ATC1B4800P1F1E0 Command SummaryType Command Description $DSUACL SNGA..H$DSUBCL $DSUASP#MA CommandDescriptionGeneral Commands Store New H command menu is as follows General HelpParameters HelpH5 menu is as follows H4 menu is as followsH6 menu is as follows H7 menu is as followsChannel Parameter Commands DTR ENQ/ACKMLA/B/D SB2 SB1$DSUCL Composite Link Speed and Clocking Commands$DSUSP $ Muxacli$MUXB Additional Composite Link CommandsList Composite Retransmit TimerReport #RBxxxxxVoice/Fax Channel Commands Command Level Silence Suppression WireLocal Interface ATV1/2LIFXOATV1/2LIFXSL Test CommandsATV1/2RIFXO ATV1/2RIFXSGT12 Command Modem CommandsT11 MultiMux Operating Procedures MultiMuxOperatingProceduresConfiguration of Port a Composite Link Configuration of Port B Composite LinkConfiguration of Port B Sync Data Voice/Fax Operating Procedures Voice/Fax Operating ProceduresCommand Modem Access on Command Modem Operating ProceduresCommand Modem Operating Procedures Command modem operation and put Introduction ImportanceofCompositeStatisticsTestCables TroubleshootingGuideData Troubleshooting Guide RD LED on RD OFF Voice/fax channel Voice/Fax Troubleshooting GuideCannot communicate Local Loop Test #4 ChannelDeviceTestingChannel Device Testing Procedure Remote Digital Loop Test #5 DSUandCommunicationsLineTestingDSU and Communications Line Testing Procedure Watch DOG Test Passed MultiMuxFunctionalTestingProceduresMultiMux Functional Testing Procedures VOICE/FAX Loopback Test #12 Voice/FaxChannelTestingVoice/Fax Channel Testing Procedure Sync Data Channel Testing Procedure SyncDataChannelTestingService, Warranty and Tech Support Repair Procedures for International Distributors AppendixA Ascii Character Code/Hex/Decimal Conversion ChartAppendix B Signal Information Negative PositiveAppendix C Cabling DiagramsDCE to DTE cabling Command Port CablesComposite Link Cabling RJ48 Cabling for Internal DSU Voice/Fax Channel Connectors RJ45 Spade Lug Wire Color FunctionDescription FXO Description FXS Description I-V Voice/Fax Channel CableAnswer a Command Name DefaultRepeat LastATH0 ATH1ATO ATQ1Register ATD5551212RRead or WriteView Active Configuration displaysUser Profiles Store ActiveATX2 ATX0ATX1 Mode While Command ExecutionReturning to After DialAppendix E Table E-1. LED IndicatorsIndicator Description FCR LED Indicators DescriptionBack Panel Power Connector ON/OFF SwitchBPS Modem DIAL-UP Line Connector Command Port TERMINAL/PC ConnectorVOICE/FAX Channel 2 FXO Connector VOICE/FAX Channel 2 FXS ConnectorVOICE/FAX Channel 1 E&M Connector VOICE/FAX Channel 1 FXS ConnectorChannel # Channel Board Number of Channels SwitchRS232C/V.35 Shunt Flow Control Background Appendix FOff Printer pacing and Flow Control Glossary of Terms Page Format Page Parameter Page Page Symbols DSU DOCLads External Composite LinkFXO FXS Load DSU Factory Defaults Command List Channel Parameters CommandMultiMux Functional Testing Procedure Link ProtocolPstn PDNREN RJ48SStdm Stop Bit Command SB1-SB2Transmit XMT Indicator Voice/Fax Input Level Gain Command Voice/Fax Channel Testing ProcedureWord Length Select Command WL5-8 Voice/Fax Channels