commands. Whether the second voice/fax channel is used depends on whether one or two instruments (telephone or fax machine) are connected. The parameters for the remote site can be displayed using the VL (List the Voice/Fax Channel Parameters) command. The voice/fax channel parameters for the remote site are shown in the Configuration 4 Remote Site Voice/Fax Channel Parameters. The voice/fax channel parameters are described in Chapter 5 Commands of this manual.
LOCAL VOICE/FAX PARAMETERS CHANNEL1 | LOCAL VOICE/FAX PARAMTERS CHANNEL 2 | ||
PARAMETER | STATUS | PARAMETER | STATUS |
DESTINATION CHANNEL: | 01 | DESTINATION CHANNEL: | 02 |
DESTINATION NODE: | 01 | DESTINATION NODE: | 01 |
LINK A/B/D: | A | LINK A/B/D: | A |
DIGITIZING RATE: | 16000 | DIGITIZING RATE: | 16000 |
OUTPUT LEVEL ATTEN.: | 09 | OUTPUT LEVEL ATTEN.: | 09 |
INPUT LEVEL GAIN: | 06 | INPUT LEVEL GAIN: | 06 |
SILENCE SUPPRESSION: | 00 | SILENCE SUPPRESSION: | 00 |
LOCAL INTERFACE TYPE: | FXS | LOCAL INTERFACE TYPE: | FXS |
GROUND/LOOP START (FXS): | LOOP | GROUND/LOOP START (FXS): | LOOP |
2 OR 4 WIRE (E&M): | 2 WIRE | 2 OR 4 WIRE (E&M): | 2 WIRE |
DIALTONE/WINK (E&M): | N/A | DIALTONE/WINK (E&M): | N/A |
WINK TIMER (E&M) | N/A | WINK TIMER (E&M) | N/A |
REMOTE INTERFACE TYPE: | FXO | REMOTE INTERFACE TYPE: | FX0 |
GROUND/LOOP START (FXS): | N/A | GROUND/LOOP START (FXS): | N/A |
2 OR 4 WIRE (E&M): | 2 WIRE | 2 OR 4 WIRE (E&M): | 2 WIRE |
DIALTONE/WINK (E&M): | N/A | DIALTONE/WINK (E&M): | N/A |