RN45B TOOL SPECIFICATIONS
All screws and nuts are metric.
MODEL | TOOL | LENGTH | HEIGHT | WIDTH | WEIGHT |
ACTUATION | |||||
Contact Trip | 10.9” (276.8mm) | 10.62” (269.7mm) | 4.62” (117.3mm) | 6lbs. (2.7kg.) | |
Sequential Trip | 10.9” (276.8mm) | 10.62” (269.7mm) | 4.62” (117.3mm) | 6lbs. (2.7kg.) | |
|
|
|
|
|
|
FASTENER SPECIFICATIONS:
This tool uses coil roofing nails in lengths of 3/4” to
TOOL AIR FITTING:
This tool uses a
OPERATING PRESSURE:
The operating pressure of the RN45B tool is 70 to 100 p.s.i. (4.9 to 7.1 kg/cm2). Select the operating pressure within this range for best fastener performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The RN45B requires 3.9 cubic feet per minute of free air to operate at the rate of 100 nails per minute, at 80 p.s.i. (5.6 kg/cm2). Take the actual rate at which the tool will be run to determine the amount of air required. For instance, if your fastener usage averages 50 nails per minute, you need 50% of the tool’s c.f.m. which is required to operate the tool at 100 nails per minute.
OPERATION
BOSTITCH OFFERS TWO TYPES OF OPERATION FOR THIS SERIES TOOL.
CONTACT TRIP:
The common operating procedure on “Contact Trip” tools is for the operator to contact the work to actuate the trip mechanism while keeping the trigger pulled, thus driving a fastener each time the work is contacted. This will allow rapid fastener placement on many jobs, such as sheathing, decking and pallet assembly. All pneumatic tools are subject to recoil when driving fasteners. The tool may bounce, releasing the trip, and if unintentionally allowed to recontact the work surface with the trigger still actuated (finger still holding trigger pulled) an unwanted second fastener will be driven.
SEQUENTIAL TRIP:
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This makes accurate fastener placement easier, for instance on framing, toe nailing and crating applications.The Sequential Trip allows exact fastener location without the possibility of driving a second fastener on recoil, as described under “Contact Trip”. The Sequential Trip Tool has a positive safety advantage because it will not accidentally drive a fastener if the tool is contacted against the work – or anything else – while the operator is holding the trigger pulled.
MODEL IDENTIFICATION:
Refer to Operation Instructions on page 7 before proceeding to use this tool.
CONTACT TRIP
Identified by:
BLACK TRIGGER
SEQUENTIAL TRIP
Identified by:
GRAY TRIGGER