Grizzly Model G0638 Test Run, To test run your dust collection system, For the G0638 only

Test Run

When the assembly is complete, test run your dust collection system to make sure it operates properly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 41.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run your dust collection system:

1.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is setup properly.

2.Make sure all tools and objects used during setup are cleared away from the machine.

3.Review Circuit Requirements on Page 11 and connect the machine to the power source.

4.Flip the main power switch at the lower left hand corner of the control box (see Figure 42).

Note: For the Model G0638, make sure the EMERGENCY STOP button is popped out by twisting the knurled knob clockwise.

EMERGENCY STOP
Button
	ON/OFF
	Button
Main Power	Timer
	Button
Switch

Figure 42. Control box (Model G0638 shown).

5.Press the ON/OFF button to turn the machine ON. Make sure your hand stays poised over the switch in case you need to quickly turn the machine OFF.

6.Listen to and watch for abnormal noises or actions. The machine should run smoothly with little or no vibration or rubbing noises.

—If you suspect any problems, immedi- ately turn the machine OFF and discon- nect the machine from power. Refer to Troubleshooting on Page 41 to identify and fix any problems.

—If you cannot solve the problem with the use of the Troubleshooting guide, contact our Tech Support at (570) 546-9663 for assistance.

7.Press the TIMER button on the control box and cycle through each of the times to make sure the indicators light.

8.Press the TIMER button on the remote con- trol and cycle through the times in the same manner as Step 7.

9.Toggle the ON/OFF button on both the con- trol box and the remote control to make sure they are working properly.

10.For the G0638 only:

a.Turn the machine OFF.

b.Press the EMERGENCY STOP button in.

c.Turn the machine ON—nothing should happen.

d.Turn the machine OFF.

e.Pop the EMERGENCY STOP button out by twisting the knurled knob clockwise.

f.Pressing the ON/OFF button should now turn the dust collector ON.

G0637/G0638 Cyclone Dust Collector -27-