Delta 36-978 Motor and Motor Mounting Plate to SAW, Motor PULLEY, Pulley GUARD, and Drive Belt

MOTOR AND MOTOR MOUNTING PLATE TO SAW

1.Insert the tapered end of pin (G) Fig. 32, into the inside holes in each side of bracket (H).

3. Assemble spring (I) Fig. 32, onto the non-tapered

end of each pin (G) as shown.

H

G

I

4.	Position motor and motor mounting plate (A) Fig. 33,
below bracket (B) to allow bracket arm to slide through
large opening (C) in motor mounting plate (A).
5.	Depress pins, one of which is shown at (D) Fig. 33,
on both sides of bracket (B) and lift up motor mounting
plate (A) until pins (D) are engaged in holes (E) Fig. 33, of
motor mounting plate (A).

G

Fig. 32

C

G

6. Fig. 34, illustrates the motor and motor mounting

plate assembled to the rear of the saw.

MOTOR PULLEY, PULLEY GUARD, AND DRIVE BELT

1.Remove the motor shaft key (No. 14, Fig. 4) that is taped to the motor.

2.Insert key (F) Fig. 35, in the keyway on the motor shaft. Assemble motor pulley (G) on motor shaft as shown, with the hub of the pulley out. Tighten set screw (H) against key (F) in motor shaft.

A

B

D

E

Fig. 33

Fig. 34

F

H

G

Fig. 35

15