Delta 36-978 instruction manual Stand and Mobile Base Parts, Sheet Metal Extension Wings

Page 9

EXTENSION WINGS

MODEL 36-978

2 SHEET METAL

EXTENSION WINGS

MODEL 36-979

2 CAST IRON EXTENSION

WINGS

Fig. 2

STAND AND MOBILE BASE PARTS

25

26

24

2829

30

27

33

35

34

31

32

Fig. 3

24.Plastic Foot (4)

25.Corner Bracket (left side)

26.Corner Bracket (right side)

27.Wheel (2)

28.Short Side Leg Support (2)

29.Long Side Leg Support (2)

30.Leg (4)

31.Short Panels For Back and Front (2)

32.Long Panels for Sides (2)

33.Leveling Feet (2)

34.Foot Lever Assembly

35.Caster Assembly

9

Image 9
Contents Model 36-979 Shown With Model 36-B30 Fence System Contractor’s SawImportant Safety Instructions Table of ContentsTool Warning Labels Safety GuidelinesImportant Safety Instructions General Safety RulesSome Materials are TOO Hard Additional Specific Safety RulesPower Connections Motor SpecificationsGrounding Instructions Extension Cords Volt Single Phase OperationFunctional Description Carton ContentsStand and Mobile Base Parts Extension WingsSheet Metal Extension Wings Cast Iron Extension WingsUnpacking and Cleaning AssemblyAssembly Tools Required Assembly Time EstimateFront and Side Panels Mobile Base and Stand AssemblyShort and Long LEG Supports Corner BracketsOpen END is Aligned AS Shown in Figs Attaching Foot Lever Assembly to BaseAS Shown in FIG Leveling Feet WheelsDust Chute and Back Brace Mobile Base and Stand Assembly to SAWWrench Hook Blade Tilting Raising HandwheelMotor to Motor Mounting Plate E FMotor PULLEY, Pulley GUARD, and Drive Belt Motor and Motor Mounting Plate to SAWTo the Arbor Pulley Removing Motor for Transport Connecting Motor Cord to Switch AssemblyBlade Guard and Splitter Assembly and Alignment Assemble the blade guard and splitter assembly Model 36-979 only Model 36-978 onlyLocking Switch in the OFF Position ON/OFF SwitchOperation Starting and Stopping SAWOverload Protection Disconnect Machine from Power SourceRaising and Lowering Blade Tilting the BladeAdjusting Table Insert Miter Gauge Operation and AdjustmentAssembling Miter Gauge Table Insert a should Always be Level with the TableChanging the SAW Blade Aligning Miter Slots to BladeMachine USE Quick Operations ChecklistBack View KEY Parts and Safety Features on Your SAWCROSS-CUTTING Blade Guard and Splitter USEMitering Never USE the Fence AS a CUT-OFF Gauge When CROSS-CUTTINGBevel Crosscutting Compound MiteringConstructing a Push Stick RippingBevel Ripping Using Moulding CutterheadFig. S15 Using Accessory Dado HeadFig. S18 Using Auxiliary Wood FacingTroubleshooting Power Tool InstituteConstructing a Featherboard Constructing a Push Stick Push StickShelf Measurements MaintenanceService AccessoriesWarranty Delta Machinery
Related manuals
Manual 100 pages 12.32 Kb