Delta 36-978 Removing Motor for Transport, Connecting Motor Cord to Switch Assembly

9.Place a ¼" flat washer and then a spacer (P) onto the ¼-20x1-1/2" hex head screw (L) Fig. 37. Then thread a ¼-20 Hex Nut (Q) Fig. 37, onto the screw post until it tightens the spacer onto the pulley guard

(I) Fig. 37.

10.Align the hole (S) Fig. 40 in the belt guard (R) with the ¼-20x1 ½" hex head screw (L) Fig. 37. Place the screw through the hole in the belt guard (R) Fig. 40. Place a ¼" External Tooth Lockwasher onto the hex head screw and thread a 1/4-20 Wing Nut onto the hex head screw, and tighten securely.

MAKE CERTAIN THE BELT GUARD DOES NOT TOUCH THE DRIVE BELT

OR MOTOR PULLEY.

CONNECTING MOTOR CORD TO SWITCH ASSEMBLY

Insert the pronged motor plug (A) Fig. 41, into the female receptacle (B) of switch-to-motor cord, which is located inside the saw housing.

MAKE SURE THE CORD RUNNING

FROM THE SWITCH TO THE FEMALE END (B) FIG. 41 IS CLAMPED TO THE INNER WALL OF THE SAW UNIT AND WILL NOT COME IN CONTACT WITH THE BLADE OR ANY MOVING PARTS.

Fig. 42 illustrates the motor cord connected to the switch assembly.

REMOVING MOTOR FOR

TRANSPORT

To remove the motor for transport through narrow doorways, first unplug the motor cord from the switch cord. Then, while holding the motor, press in on pins

(G) Fig. 32 and lower motor off of bracket (B) Fig. 33.

S

R

Fig. 40

B

A

Fig. 41

Fig. 42

17