Seiko Group OFL-126001 Parts Nomenclature, External View of OFL-12 and Operating Panel

Page 13

2.1 PARTS NOMENCLATURE

The parts of the OFL-12 basic machine are explained in this section. Figure 2-1 shows the OFL-12 after the polishing disks have been installed on the machine.

Fiber holder

Weight arm

Polishing disk	Fuse holder (2 places
	on the back side)
Protection cover
Timer

OFF button	POWER lamp
Counter	Power switch
	ON button
Reset button (Counter)

Figure 2-1 External View of OFL-12 and Operating Panel

2 - 2

Image 13

Contents Document Number 39NPI-53E1-03 Mass Production PolisherOFL-12 Series Document Number 39NPI-53E1-03 Seiko Instruments USA Inc Seiko Instruments GmbHPreface Part Part code Qty Remarks Standard Parts Can polish approximately Section Viii Chapter User Notes Precautions for Using the OFL-12Preparation Precautions for Using Polishing Fluid Chapter Overview External View of OFL-12 and Operating Panel Parts NomenclaturePage Page Protection Cover Operational Procedure Page Page Polishing Disk Preparation Chapter Polishing PreparationPolishing Film Preparation No. Weight Set Point Thrust Polishing Pressure SettingFerrules Grinding Polishing Finishing Procedure of setting up polishint time Setting UP Polishing TimeMounting the Ferrules Chapter Polishing ProcedureMake sure that the ferrules do Balanced Ferrule Arrangements Ferrule mounting is complete Removing Adhesive Hand Polishing Adjusting Fiber Holder Grinding 1ST Polishing and Polishing 2ND Polishing Page Soft brush Holding jig Step Clean the tips of the ferrules With cleaning paper Finishing 3RD Polishing Page Other matter Speckles Slight Scratch Polishing Condition CheckFiber Scratch or Large Polishing Fluid Remaining Cleaning After Polishing Chapter MaintenanceChanging the Polishing Film Page Chapter Troubleshooting Troubleshooting Chart EMC Appendix Standard Polishing Efficiency and SpecificationsOperating environmental specifications Operating temperature