Seiko Group OFL-127001, OFL-126001 Chapter Polishing Procedure, Mounting the Ferrules

4.1 MOUNTING THE FERRULES

V-grove

Ferrule

Clamping screw

Holding jig

Step 1 Place the setup stand on a desk or table and put the holding jig onto the setup stand, fitting the hole in the holding jig onto the pin on the setup stand.

Step 2 Loosen the clamping screws on the holding jig, turning about 3 turns using the ball- end hex wrench.

Step 3 Place the ferrules into the V- grooves in the holding jig. See Figure 4-1 for where to place the ferrules to have a balanced pattern.

Step 4 On each side of the holding jig, tighten the clamping screw with the ball-end hex wrench while lightly pushing the flange on the ferrules against the holding jig.