Seiko Group OFL-126001, OFL-127001, OFL-12 SERIES instruction manual Adjusting Fiber Holder

4.3 ADJUSTING FIBER HOLDER

This section describes how to adjust the height of the fiber holder. This adjustment is done when mounting the holding jig onto the polishing unit. Refer to sections 4.4 and 4.5.

		Step 1	Hang the looped fibers (which
			have been tied into two
			bundles) on the spool at the
			end of the fiber holder (at the
			lowest position).
		Step 2	Mount the holding jig onto the
			polishing unit as described in
			steps 4 and 5 of sections 4.4
			and 4.5.
	Fiber holder	Step 3	Loosen the clamping knob for
			the fiber holder and slide the
			fiber holder up so that the
			fibers will not interfere with the
			polishing.
Weight	Fibers	Step 4	Tighten the clamping knob to
			clamp the fiber holder in place.

Clamping knob	NOTE
	Always hang the fibers on the
	fiber holder so that they do not
	affect the weight. In this case
Polishing unit polishing may not		be done
	correctly because the	adaquate
	polishing pressure is not applied
	to the holding jig.

4 - 5