Seiko Group OFL-127001, OFL-126001, OFL-12 SERIES Removing Adhesive Hand Polishing

Adhesive removal pad

Figure-8 motion

4.2 REMOVING ADHESIVE (HAND POLISHING)

Holding jig

Abrasive paper (for adhesive removal)

Step 1 Clean the surface of the synthetic rubber sheet with ethyl alcohol. Make sure all dirt and other foreign matter is removed.

Step 2 Place a new piece of abrasive paper onto the rubber pad.

Step 3 Take the holding jig with the ferrules mounted in it and rub the tips of the ferrules against the abrasive paper using a figure-8 motion. Rub for about 10 seconds using only the weight of the holding jig, then for about 20 seconds with about 1 to 2 kg (2.2 to 4.4 lbs) of hand pressure.

Step 4 Clean the tips of the ferrules with cleaning paper. Make sure that there is no adhesive remaining on the tips of the ferrules. Use a new piece of abrasive paper every time this polishing step is done.

NOTE

If the ferrules are mounted incorrectly, the ferrule can slip and the tip of the ferrule may not be polished correctly.

4 - 4