Seiko Group OFL-12 SERIES, OFL-127001 Step Clean the tips of the ferrules With cleaning paper

Page 32

 

Step 12

Clean the tips of the ferrules

 

 

with cleaning paper.

Fluorescent lights

Step 13

(Only after grinding.) Make

 

 

 

sure that the polished surface

 

 

is clean.

Polished surface

Ferrule Straight lines

NOTE

Don’t take the ferrules out of the holding jig yet.

Check the ferrule tip surface. If the reflection of two parallel fluorescent light tubes is parallel, the polishing is satisfactory. If the reflection is not parallel, redo the grinding step.

Step 14 Clean the surface of the polishing film with cleaning paper and water.

Distorted lines

Step 15 Replace the polishing film for grinding with the polishing film for polishing (yellow label), then set the weight position for polishing. Repeat procedures 2 through 12 (except for step 11) using the polishing film for polishing.

4 - 9

Image 32
Contents Mass Production Polisher Document Number 39NPI-53E1-03OFL-12 Series Seiko Instruments USA Inc Seiko Instruments GmbH Document Number 39NPI-53E1-03Preface Part Part code Qty Remarks Standard Parts Can polish approximately Section Viii Preparation Precautions for Using the OFL-12Chapter User Notes Precautions for Using Polishing Fluid Chapter Overview Parts Nomenclature External View of OFL-12 and Operating PanelPage Page Protection Cover Operational Procedure Page Page Chapter Polishing Preparation Polishing Disk PreparationPolishing Film Preparation Ferrules Grinding Polishing Finishing Thrust Polishing Pressure SettingNo. Weight Set Point Setting UP Polishing Time Procedure of setting up polishint timeChapter Polishing Procedure Mounting the FerrulesMake sure that the ferrules do Balanced Ferrule Arrangements Ferrule mounting is complete Removing Adhesive Hand Polishing Adjusting Fiber Holder Grinding 1ST Polishing and Polishing 2ND Polishing Page Soft brush Holding jig Step Clean the tips of the ferrules With cleaning paper Finishing 3RD Polishing Page Other matter Polishing Condition Check Speckles Slight ScratchFiber Scratch or Large Polishing Fluid Remaining Changing the Polishing Film Chapter MaintenanceCleaning After Polishing Page Chapter Troubleshooting Troubleshooting Chart Appendix Standard Polishing Efficiency and Specifications EMCOperating environmental specifications Operating temperature