Seiko Group OFL-127001, OFL-126001, OFL-12 SERIES Seiko Instruments USA Inc Seiko Instruments GmbH

Page 3

OFL-12 SERIES OFL-126001 OFL-127001 MASS PRODUCTION POLISHER INSTRUCTION MANUAL

Document Number 39NPI-53E1-03

First Edition

March 1995

Second Edition November 1995

Third Edition

March 1996

Copyright 1995, 1996 by Seiko Instruments Inc.

All rights reserved.

Seiko Instruments Inc. (SII) has prepared this manual for use by SII personnel, licensees, and customers. The information contained herein is the property of SII and shall not be reproduced in whole or in part without the prior written approval of SII.

SII reserves the right to make changes without notice to the specifications and materials contained herein and shall not be responsible for any damages (including consequential) caused by reliance on the materials presented, including but not limited to typographical, arithmetic, or listing errors.

SII is a trademark of Seiko Instruments Inc.

Please address any questions, comments, and suggestions to:

Seiko Instruments USA Inc.

Seiko Instruments GmbH

Electronic Components Div.

OFC Div.

2990 West Lomita Boulevard,

Siemensstra ￿e 9,

Torrance, CA 90505, U.S.A.

63263 Neu-Isenburg, Germany

Telephone: 310-517-8113

Telephone: 6102-2970

Facsimile: 310-517-7792

Facsimile: 6102-297222

Seiko Instruments (H.K.) Ltd.

Seiko Instruments Taiwan Inc.

Sales Dept.

Sales Dept.

4￿5th Floor, Wyler Center 2, 200

5f-1, No.99, Sec.2, Chung shan.Rd.,

Tai Lin Pai Road Kwai chung, N.T.,

Taipei 104, Taiwan, R.O.C

Kowloon, Hong Kong.

Telephone: 886-2-5635001, 5235111

Telephone: 852-421-8611

Facsimile: 886-2-5219519

Facsimile: 852-480-5479

 

- ii -

Image 3
Contents Document Number 39NPI-53E1-03 Mass Production PolisherOFL-12 Series Document Number 39NPI-53E1-03 Seiko Instruments USA Inc Seiko Instruments GmbHPreface Part Part code Qty Remarks Standard Parts Can polish approximately Section Viii Precautions for Using the OFL-12 Chapter User NotesPreparation Precautions for Using Polishing Fluid Chapter Overview External View of OFL-12 and Operating Panel Parts NomenclaturePage Page Protection Cover Operational Procedure Page Page Polishing Disk Preparation Chapter Polishing PreparationPolishing Film Preparation Thrust Polishing Pressure Setting No. Weight Set PointFerrules Grinding Polishing Finishing Procedure of setting up polishint time Setting UP Polishing TimeMounting the Ferrules Chapter Polishing ProcedureMake sure that the ferrules do Balanced Ferrule Arrangements Ferrule mounting is complete Removing Adhesive Hand Polishing Adjusting Fiber Holder Grinding 1ST Polishing and Polishing 2ND Polishing Page Soft brush Holding jig Step Clean the tips of the ferrules With cleaning paper Finishing 3RD Polishing Page Other matter Speckles Slight Scratch Polishing Condition CheckFiber Scratch or Large Polishing Fluid Remaining Chapter Maintenance Cleaning After PolishingChanging the Polishing Film Page Chapter Troubleshooting Troubleshooting Chart EMC Appendix Standard Polishing Efficiency and SpecificationsOperating environmental specifications Operating temperature