NOTE
Make sure that the weight arm lever goes to the full up position. If it does not, the correct polishing pressure will not be applied to the holding jig and polishing will not be performed correctly.
Step 6 Set the timer to 1 min. (standard).
Preparation for polishing is complete.
NOTE
The first time a sheet of finishing polishing film is used, the polishing fluid will not completely soak into the polishing film. Therefore, when using a sheet of finishing polishing film for the first time, polish twice (1 minute each).
Step 7 Press the ON button. The polishing disk begins to rotate and polishing begins.
NOTE
Press the OFF button if there is any problem. The polishing disk will stop rotating and polishing will stop.
Step 8 The polishing will automatically stop when the time set on the timer is up. After the polishing is completed, pull the weight arm lever toward you and remove the holding jig from the polishing disk.
4 - 11