Seiko Group OFL-127001, OFL-126001, OFL-12 SERIES instruction manual Finishing 3RD Polishing

4.5 FINISHING (3RD POLISHING)

Weight

Weight arm lever

Rotation stop pin

Holding jig

Notch in holding jig

Rotation stop pin

Thrust pin

Notch in holding jig

Step 1 Replace the polishing film for polishing with the polishing film for finishing (white label), then set the weight position for finishing.

Step 2 Pull the weight arm lever toward you.

Step 3 Using the squeezable dropper bottle, apply polishing fluid to the entire surface of the polishing film.

NOTE

Apply 2 ml or more polishing fluid

Step 4 Put the holding jig (after completing the polishing step) onto the polishing film with the rotation stop pin in the notch in the holding jig.

Step 5 Lift the weight arm lever up, setting the thrust pin into the hole in the center of the holding jig.