Soft brush
Holding jig
Step 10 The polishing will automatically stop when the time set on the timer is up. After the polishing is completed, pull the weight arm lever toward you and remove the holding jig from the polishing disk.
NOTE
Ferrule tip
When removing the holding jig
Water from the polishing unit, lift the holding jig up so the ferrules do not touch the polishing film.
Step 11 Clean the holding jig and the tips of the ferrules under running water using the brush. After cleaning, clean the brush, removing all polishing grit or other matter.
This illustration shows running water being used for washing. (There is no problem if washing is done in the washing container, but using running water is preferred.)
NOTE
After cleaning, remove waterdrops completely from the holding jig.
NOTE
Do not touch the operation panel with wet hands.
4 - 8