Miller Electric XMS 44 owner manual Changing Cable Between Wire Feeder and XMS

Page 14

3-8. Changing Cable Between Wire Feeder and XMS 4000

2

1

Tools Needed:

3

3

YDisconnect power before changing cables.

1Access Door

2Clamp

3Plastic Collar

Connect weld cable to terminals be- hind access door.

Remove screws securing door, clamp and collar. Make cable con- nections. Reinstall clamp, collar, and door.

3-9. Installing Wheels On Wire Feeder (Optional)

1 Wheels

2 Bars

3 Screws

Remove rubber feet from wire feeder.

Install only wheels on feeder if smaller dimensions are desired, unit will be used on level floors, or if optional turn- table is used.

Install wheels and bars for increased stability on uneven floors.

1 3

1

Tools Needed:

OM-223 839 Page 10

Image 14

Contents Description OM-223 839BProcesses From Miller to You Table of Contents Directives StandardsArc Welding Hazards Symbol UsageMarks a special safety message Electric Shock can killFlying Metal can injure eyes ARC Rays can burn eyes and skinWelding can cause fire or explosion Buildup of GAS can injure or killCalifornia Proposition 65 Warnings About Pacemakers Principal Safety StandardsEMF Information − Definitions Manufacturer’s Warning Label DefinitionsManufacturer’s Rating Labels Symbols And Definitions Symbols found on productRemote 7 Receptacle Information Specifications− Introduction Pin Plug InformationAligning Wire Guide And Drive Rolls Connecting Welding GunInstalling Wire Guide And Drive Roll Connecting Wire Feeder to Power Source Circuit ProtectionDisconnect power before changing cables Changing Cable Between Wire Feeder and XMSInstalling Wheels On Wire Feeder Optional − Operation Control PanelSwitching On Unit And Recalling Factory Parameters Welding Process SelectionTrigger Mode Selection Setup Menu and Memory Menu SelectionMemory Menu Setup MenuSetting Menu Type Jog And Purge SelectionPreparing Unit For MIG Welding Selecting Manual MIG Welding Selecting Synergic MIG Welding Selecting Synergic Pulsed MIG Welding P1 P2 P3− Maintenance & Troubleshooting HLPTroubleshooting Problem Solution− Electrical Diagram − Parts List Main AssemblyDia Part Description Quantity Mkgs Wire Drive Assembly Drive Roll And Wire Guide Kits 4 Drive Roll Wire Diameter Kit No Drive Roll Wire GuidePage Effective January 1 Owner’s Record ITW Welding Products Italy S.r.l. Via Privata Iseo, 6/E