Miller Electric XMS 44 owner manual Directives, Standards

Page 4

Declaration of Conformity for

European Community (CE) Products

NOTE

This information is provided for units with CE certification (see rating label on unit).

Manufacturer:

ITW Welding Products Italy S.r.l. Via dell’Industria, 55

36030 Sarcedo

Vincenza, Italy

Phone: 39(0445)367706

European Contact:

Mr. Danilo Fedolfi,

Managing Director

ITW Welding Products Italy S.r.l. Via Privata Iseo 6/E

20098 San Giuliano Milanese, Italy Phone: 39(02)98290-1 Fax: 39(02)98290203

European Contact Signature:
Declares that this product:	XMS 44

conforms to the following Directives and Standards:

Directives

Low Voltage Directive: 73/23/EEC

Electromagnetic compatibility Directives: 89/336/EEC, 92/31/EEC

Machinery Directives: 89/392/EEC, 91/368/EEC, 92/31/EEC, 133/04, 93/68/EEC

Standards

Electromagnetic Compatibility (EMC) Product standard for arc welding equipment: EN50199: August 1995

Safety Requirements for Arc Welding Equipment part 1: IEC 60974-1 1990

Degrees of Protection Provided By Enclosures (IP Code): IEC 529 1989

Insulation Coordination For Equipment Within Low-Voltage Systems:

Part 1: Principles, Requirements And Tests. IEC 664-1 1992

The product technical file is maintained by the responsible Business Unit(s) located at the manufacturing facility.

dec_stat_Milan_6/05

Image 4

Contents Processes OM-223 839BDescription From Miller to You Table of Contents Directives StandardsSymbol Usage Marks a special safety messageArc Welding Hazards Electric Shock can killARC Rays can burn eyes and skin Welding can cause fire or explosionFlying Metal can injure eyes Buildup of GAS can injure or killCalifornia Proposition 65 Warnings EMF Information Principal Safety StandardsAbout Pacemakers − Definitions Manufacturer’s Warning Label DefinitionsManufacturer’s Rating Labels Symbols And Definitions Symbols found on productSpecifications − IntroductionRemote 7 Receptacle Information Pin Plug InformationInstalling Wire Guide And Drive Roll Connecting Welding GunAligning Wire Guide And Drive Rolls Connecting Wire Feeder to Power Source Circuit ProtectionInstalling Wheels On Wire Feeder Optional Changing Cable Between Wire Feeder and XMSDisconnect power before changing cables − Operation Control PanelSwitching On Unit And Recalling Factory Parameters Welding Process SelectionTrigger Mode Selection Setup Menu and Memory Menu SelectionSetup Menu Setting Menu TypeMemory Menu Jog And Purge SelectionPreparing Unit For MIG Welding Selecting Manual MIG Welding Selecting Synergic MIG Welding Selecting Synergic Pulsed MIG Welding P1 P2 P3− Maintenance & Troubleshooting HLPTroubleshooting Problem Solution− Electrical Diagram − Parts List Main AssemblyDia Part Description Quantity Mkgs Wire Drive Assembly Drive Roll And Wire Guide Kits 4 Drive Roll Wire Diameter Kit No Drive Roll Wire GuidePage Effective January 1 Owner’s Record ITW Welding Products Italy S.r.l. Via Privata Iseo, 6/E