Miller Electric XMS 44 Setup Menu, Memory Menu, Jog And Purge Selection, Setting Menu Type

4-6. Setup Menu

Press P2 to enter SET UP menu.	. Incorrect settings in any process can	Use E1 to select SET (setup) SHO (short)
Setup allows viewing and changing default	result in a program with undesirable	on D1 and D2 (default setting).
parameter values for all welding processes	weld characteristics. Setup should	Use E2 to change D2 to FULL.
for the desired weld characteristics.	only be used by operators familiar with	. MENU SHORT only shows basic pa-
D1 shows the welding parameter.	various welding processes and pa-
D2 shows the parameter value.	rameters.	rameters for welding processes. SET-
		UP FULL shows all parameters for
E1 changes the welding parameter.
	Setting Menu Type	welding processes. Menu selection is
E2 changes the parameter value.
		set when exiting the Setup Menu.
P2 allows to exit setup Menu and Ad-	To set menu type, proceed as follows:
vanced Programming and to save the
changed parameters.	Press P2 to enter Setup menu.

4-7. Memory Menu

Press P2 to enter Memory menu.	D1 shows the memory position.	When D2 shows dEL (delete), you can de-
D1 shows the first free memory position or	E1 changes the memory position.	lete the parameters memorized in the
the last memory used.	D2 shows the action you can perform on	memory position selected by D1.
E1 changes the memory position number	the memory position.	In order to confirm the action, press P2 until
from P.01 to P.99.	E2 changes the action on the memory posi-
		D1 and D2 flash.
Any memory position contains all the se-	tion.
		Release P2 and wait until flashing stops.
lected MIG welding parameters in the Wire
		The action is now performed and the weld-
Feeder and in the Power Source.	When D2 shows Ld (load), you can load in
		er exits the Memory menu.
When a memorized welding point is loaded	the welder the parameters in the memory	. Do not perform any operation on the
the Wire Feeder and the Power Source is	position selected by D1.
set accordingly.	When D2 shows Sto (storage), you can	welder when in Memory menu to pre-
Verify the Power Source status before	memorize the actual welding parameters in	vent incorrect weld parameters and
welding, if needed.	the memory position selected by D1.	poor operation.

4-8. Jog And Purge Selection

L15

L16

P3

.If a function is selected and not used

within several seconds, the LED will turn off .

To use the jog and purge function, proceed as follows:

Pressing P3 once selects jog. Pressing P8 a second time selects purge.

When L15 illuminates, press and hold P3 to perform jog function.

Jog feeds welding wire without weld output power applied to the wire.

In Jog mode, D1 shows JOG and D2 shows wire feed speed.

Use E2 to change wire feed speed setting.

.Jog will be performed if gun trigger is

pressed and held without striking a welding arc. Front panel Jog is recom- mended.

When L16 illuminates, press and hold P3 to perform purge function.

.Purge is used to remove impurities and

fill the gas hose with shielding gas. Pre−Gas is a similar function, but only operates at the beginning of a welding process. Purge can be performed in the TIG process by pressing the torch trigger without striking an arc.

OM-223 839 Page 14