Hitachi G 12SA2, G 13SB2 instruction manual Maintenance and Inspection

English

MAINTENANCE AND INSPECTION

WARNING: ⬤ Be sure to switch power OFF and disconnect the plug from the receptacle during maintenance and inspection.

⬤Using cracked, deformed or damaged wheels can lead to wheel breakage and resulting serious injury.

1.Replacing the depressed center wheel

Replace the depressed center wheel when it has been worn out to about 2-3/8" (60mm) in external diameter. Confirm that there is no crack or any damage to the depressed center wheel. If there is a crack or a transformation in the wheel, replace it immediately.

2.Inspecting the screws

Regularly inspect all screws and ensure that they are fully tightened. Should any of the screws be loosened, retighten them immediately.

WARNING: Using this grinder with loosened screws is extremely dangerous.

3. Confirm that there is no damage in the

wheel guard, the electrical cord and the

housing, etc.

No. of carbon

Wear limit brush

Check that the on/off switch operates

normally.

4. Inspecting the carbon brushes (Fig. 6)

The motor employs carbon brushes which

are consumable parts. Replace the carbon

brush with a new one when it becomes

worn to its wear limit. Always keep carbon

88

0.67" (17mm)

0.24" (6mm)

brushes clean and ensure that they slide

freely within the brush holders.

Fig. 6

CAUTION: Using this grinder with a carbon brush which is worn in excess of the wear limit will damage the motor.

NOTE: Use HITACHI carbon brush No. 88 indicated in Fig. 6.

◯ Replacing carbon brushes:
<Disassembly>
(1) Loosen the D4 tapping screw retaining
the tail cover and remove the tail cover.
(2) Use the auxiliary hexagonal wrench or		Spring
small screwdriver to pull up the edge
of the spring that is holding down the	Carbon Brush
carbon brush. Remove the edge of the		Brush Holder
spring toward the outside of the brush		Fig. 7
holder.

15