Chapter 2 Installing the Access Point
Deploying the Access Points on the Wireless Network
b.Mount the access point at the indicated destination using the specified mounting method. For specific instructions, see these sections:
–Horizontal or vertical surface, such as a ceiling or wall (refer to the Mounting on a Horizontal or Vertical Surface, page
–Below a suspended ceiling (refer to the “Mounting on a Suspended Ceiling” section on page
–Above a suspended ceiling (refer to the “Mounting Above a Suspended Ceiling” section on page
–On a cubicle wall (refer to the “Mounting on a Cubical Wall Partition” section on page
–On a desktop (see the “Using the Desktop Holster” section on page
c.Optionally secure the access point using a padlock or security cable (refer to the “Using the Security Hasp Adapter” section on page
d.Connect the access point cables (Ethernet, optional power, optional antennas). For instructions see the “Connecting the Ethernet and Power Cables” section on page
e.On power up, verify that the access point is operating normally by checking the LEDs. For additional information, refer to the “Checking the Autonomous Access Point LEDs” section on page
Step 4 For lightweight access points, after your access points are deployed, ensure that your controller is not configured as a master controller. A master controller should only be used for configuring access points and not in a working network.
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
|
| |
|