Chapter 3 Mounting Instructions
Overview
Overview
The mounting brackets and hardware shipped with your access point enables you to mount it on any of the following surfaces:
•Horizontal or vertical flat surfaces, such as walls or ceilings
•Suspended ceilings
•Cubical partition walls
•Desktop or other suitable horizontal surface
The 1100 series access point provides adequate fire resistance and low
Caution Only the
Security features for each of these mounting methods are also provided. You can use a Kensington lock (Notebook Microstar, model number 64068), which you must provide, to make the access point more secure when you mount it using any of the mounting options.
You can use the security hasp adapter provided by Cisco to secure the access point with a padlock when you use the wall or ceiling mounting bracket. The security hasp adapter provides maximum physical security for your access point.
A mounting hardware kit is provided that contains the hardware and fasteners necessary to mount the access point. Refer to Table
Table | Mounting Material |
| |
|
|
| |
Mounting Method | Materials Required | In Kit | |
|
|
| |
Horizontal or vertical surface | Wall or ceiling mounting bracket | Yes | |
|
| Security hasp adapter | Yes |
|
| Four #8 x 1 in. (25.4 mm) screws | Yes |
|
| Four wall anchors | Yes |
|
| 3/16 in. (4.7 mm) or 3/32 in. (2.3 mm) drill bit | No |
|
| Drill | No |
|
|
| |
Suspended ceiling | Wall or ceiling mounting bracket | Yes | |
|
| Security hasp adapter | Yes |
|
| Two caddy fasteners with studs | Yes |
|
| Two plastic spacers | Yes |
|
| Two | Yes |
|
| Standard screwdriver | No |
|
| Appropriate wrench or pliers | No |
|
|
| |
Office cubical wall partition | Cubical partition mounting bracket assembly | Yes | |
|
|
|
|
Desktop |
| Desktop holster | Yes |
|
|
|
|
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
|
| |
|