Cisco Systems ASA5512AW1YPR, ASA5515K9, kygjygcjgf manual Configuring Equipment Racks, CAB-IND-10A

Chapter 2 Preparing for Installation

General Site Requirements

Table 2-1 AC-Input Power Cord Options (continued)

Locale	Part Number	Length	Plug Rating	Plug Type
India	CAB-IND-10A	8.2 ft (2.5 m) 250 VAC, 10 A
	(37-0863-01)
				331705

South Africa

AIR-PWR-CORD-S A

(37-0346-01)

8.2 ft (2.5 m)

250 VAC, 10 A

331706

Configuring Equipment Racks

The following tips help you plan an acceptable equipment rack configuration:

•Enclosed racks must have adequate ventilation. Ensure that the rack is not overly congested because each chassis generates heat. An enclosed rack should have louvered sides and a fan to provide cooling air.

•When mounting a chassis in an open rack, ensure that the rack frame does not block the intake or exhaust ports. If the chassis is installed on slides, check the position of the chassis when it is seated all the way into the rack.

•In an enclosed rack with a ventilation fan in the top, excessive heat generated by equipment near the bottom of the rack can be drawn upward and into the intake ports of the equipment above it in the rack. Ensure that you provide adequate ventilation for equipment at the bottom of the rack.

•Baffles can help to isolate exhaust air from intake air, which also helps to draw cooling air through the chassis. The best placement of the baffles depends on the airflow patterns in the rack. Experiment with different arrangements to position the baffles effectively.

Cisco ASA 5500-X Series Hardware Installation Guide

2-6