Cisco Systems ASA5525IPSK9, ASA5515K9 manual Installing an I/O Card, Replacing the Chassis Cover

Chapter 4 Maintenance and Upgrade Procedures for the ASA 5500-X

Installing an I/O Card

Figure 4-2 Replacing the Chassis Cover

1

282616

1

Thumbscrew

Step 3	Reinstall the chassis on a rack.
Step 4	Reinstall the network interface cables.
Step 5	Power on the chassis.

Installing an I/O Card

•Installing an I/O Card in the Cisco ASA 5512-X,5515-X, and 5525-X Chassis, page 4-3

•Installing an I/O Card in the Cisco ASA 5545-X and 5555-X Chassis, page 4-7

Installing an I/O Card in the Cisco ASA 5512-X, 5515-X, and 5525-X Chassis

To remove an existing I/O card and install a new one, perform the following steps.

Detailed Steps

Step 1 Power off the chassis, remove the power cable from the chassis, and remove the chassis from the rack.

Step 2 Locate a grounding strap, and fasten it to your wrist so that it contacts bare skin. Attach the other end to the chassis. See the “Working in an ESD Environment” section on page 2-3for more information.

Step 3 With a Phillips head screwdriver, loosen the captive installation screw on the rear of the chassis

Step 4 Remove the chassis cover by placing your hand on top of the chassis lid, pressing down firmly, and pushing the cover toward the rear of the chassis.

Step 5 Determine the location of the I/O card. (See Figure 4-3.)

Cisco ASA 5500-X Series Hardware Installation Guide

4-3