Cisco Systems ASR 1004 quick start Installing the DC Ground Lugs

Page 17

Figure 10 shows the DC power supply for the Cisco ASR 1004 Router.

DC Power Supply for the Cisco ASR 1004 Router

		1		2
			OUTPUT INPUT FAN
			FAIL	OK	OK
			60V
			1A MAX
			OUTPUT INPUT FAN
			FAIL	OK	OK
			60V
			1A MAX
					280185
7	6	5	4	3

1	DC power supply terminal block and plastic cover	5	DC power supply earth ground symbol

2	DC power supply LEDs	6	DC power supply On (I)/ Off (O)

3	DB-25 alarm connector	7	DC power supply handle

4	DC power supply fan

The Cisco ASR1004 has two of the same type power supplies in power supply Slot 0 and power supply Slot 1.

Caution Before you connect DC-input power, you must install the DC power ground leads to the DC power supply.

Caution To make sure that the equipment is reliably connected to earth ground, follow the grounding procedure instructions.

Obtain these necessary tools and equipment:

•Number 2 Phillips screwdriver

•A 3/16-inch flat-blade screwdriver

Installing the DC Ground Lugs

To install the grounding lugs on the DC power supply, follow these instructions. Figure 11 shows the location of the DC power supply grounding stud.

17

Image 17

Contents Cisco ASR 1004 Router Document Revision History Documentation and ResourcesPrepare for Equipment Shelf or Tabletop Installation Prepare for InstallationSite Preparation and Unpacking Tools and PartsAttach the Rack-Mount Brackets-Chassis Front-Mounted Prepare for Rack-Mount InstallationRack-Mount the Router Attach the Rack-Mount Brackets-Chassis Rear-Mounted Installing the Cisco ASR 1004 Router in a Four-Post Rack Four-Post Rack InstallationPage Installing a Cisco ASR 1004 Router in a Two-Post Rack Two-Post Rack InstallationAttach the Cable-Management Bracket Chassis Ground Connection Installation Chassis ground connector on the Cisco ASR 1004 Router Console and Auxiliary Port Cable Connections Connect the Router to the NetworkManagement Ethernet Port Cable Connection Cisco ASR1000-RP1 Enet Management Port ConnectorConnect AC Power to the Router Install Cables in the Cable-Management BracketStart the System Connect the Shared Port Adapter CablesCisco ASR 1004 Router AC Power Supply Connect DC Power to the RouterUnit. Statement Installing the DC Ground Lugs Wiring the DC-Input Power Source Cisco ASR 1004 Router DC Power Supply Terminal Block Start the Cisco ASR 1004 Router Verifying Power Supply OperationLED Page Page Configure Global Parameters Using the Setup Facility Configure the RouterUsing the Console Interface OK? No clns routing Tftptimeout Page Perform Other Configuration Tasks Check the Running Configuration SettingsSave the Running Configuration to Nvram Remove and Replace a Power Supply After InstallationPower Off the Cisco ASR 1004 Router Remove and Then Replace a DC Power Supply Page End View All measurements in inches 267 Holes Install and Remove the SPA Interface Processor SIP ASR1000-SIP10 Remove the Shared Port AdapterPage USA