Cisco Systems ASR 1004 quick start

Page 36

Caution The shared port adapter must slide into the slot guides under the chassis lid. Do not allow the shared port adapter

components to come in contact with the system board or the shared port adapter could be damaged.

Step 6 Carefully slide the shared port adapter into the shared port adapter slot and seat it. When installed, the shared port adapter input/output panel should be flush with the face of the router.

Step 7 Reconnect any cables, including the shared port adapter and power cables, and place the cables through any cable-management bracket.

Note If the shared port adapter fails to come up, reseat or reinsert the shared port adapter: do not use excessive force.

Step 8 Power on the router by turning the power switch to the On() position.

36

Image 36

Contents Cisco ASR 1004 Router Documentation and Resources Document Revision HistoryPrepare for Installation Prepare for Equipment Shelf or Tabletop InstallationSite Preparation and Unpacking Tools and PartsPrepare for Rack-Mount Installation Rack-Mount the RouterAttach the Rack-Mount Brackets-Chassis Front-Mounted Attach the Rack-Mount Brackets-Chassis Rear-Mounted Four-Post Rack Installation Installing the Cisco ASR 1004 Router in a Four-Post RackPage Two-Post Rack Installation Installing a Cisco ASR 1004 Router in a Two-Post RackAttach the Cable-Management Bracket Chassis Ground Connection Installation Chassis ground connector on the Cisco ASR 1004 Router Connect the Router to the Network Console and Auxiliary Port Cable ConnectionsCisco ASR1000-RP1 Enet Management Port Connector Management Ethernet Port Cable ConnectionInstall Cables in the Cable-Management Bracket Connect AC Power to the RouterStart the System Connect the Shared Port Adapter CablesConnect DC Power to the Router Cisco ASR 1004 Router AC Power SupplyUnit. Statement Installing the DC Ground Lugs Wiring the DC-Input Power Source Cisco ASR 1004 Router DC Power Supply Terminal Block Verifying Power Supply Operation Start the Cisco ASR 1004 RouterLED Page Page Configure the Router Using the Console InterfaceConfigure Global Parameters Using the Setup Facility OK? No clns routing Tftptimeout Page Check the Running Configuration Settings Save the Running Configuration to NvramPerform Other Configuration Tasks After Installation Power Off the Cisco ASR 1004 RouterRemove and Replace a Power Supply Remove and Then Replace a DC Power Supply Page End View All measurements in inches 267 Holes Install and Remove the SPA Interface Processor SIP Remove the Shared Port Adapter ASR1000-SIP10Page USA