Cisco Systems ASR 1004 quick start End View All measurements in inches 267 Holes

Page 33

Figure 13 Cisco ASR 1004 Router DC Power Supply Grounding Wire and Stud

End View

All measurements in inches

2.24

0.48

Ø0.267

2 holes

 

0.25

 

 

0.63

 

 

 

0.37

 

 

 

Crimp area

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

0.08

Step 5 Attach the other end of the ground cable to the site ground connection.

25527

Caution Before you continue to install the terminal block ground wires, stop and perform Step 6. To prevent any contact with metal lead on the ground wire and the plastic cover.

Step 6 You must wrap the positive and negative cables with sleeving. Take each wire and cover the area from the lug to the wire with heavy shrink sleeving.

Step 7 Replace the ground lug with cable in the following order:

a.Flat Washer

b.Ground lug with the positive and negative wire

c.Kepnut screw

Figure 14 Cisco ASR 1004 Router DC Power Supply Terminal Block

2

1

280187

 

5

4

 

3

 

 

 

 

 

1

Ground lug and positive lead wire

 

4

Washer

 

 

 

 

 

2

Terminal block and positive stud

 

5

Kepnut screw

 

 

 

 

 

3

Earth grounding symbol

 

 

 

 

 

 

 

 

33

Image 33
Contents Cisco ASR 1004 Router Document Revision History Documentation and ResourcesPrepare for Equipment Shelf or Tabletop Installation Prepare for InstallationSite Preparation and Unpacking Tools and PartsPrepare for Rack-Mount Installation Rack-Mount the RouterAttach the Rack-Mount Brackets-Chassis Front-Mounted Attach the Rack-Mount Brackets-Chassis Rear-Mounted Installing the Cisco ASR 1004 Router in a Four-Post Rack Four-Post Rack InstallationPage Installing a Cisco ASR 1004 Router in a Two-Post Rack Two-Post Rack InstallationAttach the Cable-Management Bracket Chassis Ground Connection Installation Chassis ground connector on the Cisco ASR 1004 Router Console and Auxiliary Port Cable Connections Connect the Router to the NetworkManagement Ethernet Port Cable Connection Cisco ASR1000-RP1 Enet Management Port ConnectorConnect AC Power to the Router Install Cables in the Cable-Management BracketStart the System Connect the Shared Port Adapter CablesCisco ASR 1004 Router AC Power Supply Connect DC Power to the RouterUnit. Statement Installing the DC Ground Lugs Wiring the DC-Input Power Source Cisco ASR 1004 Router DC Power Supply Terminal Block Start the Cisco ASR 1004 Router Verifying Power Supply OperationLED Page Page Configure the Router Using the Console InterfaceConfigure Global Parameters Using the Setup Facility OK? No clns routing Tftptimeout Page Check the Running Configuration Settings Save the Running Configuration to NvramPerform Other Configuration Tasks After Installation Power Off the Cisco ASR 1004 RouterRemove and Replace a Power Supply Remove and Then Replace a DC Power Supply Page End View All measurements in inches 267 Holes Install and Remove the SPA Interface Processor SIP ASR1000-SIP10 Remove the Shared Port AdapterPage USA